A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Chiggiato, P.

Paper Title Page
TUPC037 Development, Production and Testing of 4500 Beam Loss Monitors 1134
 
  • E. B. Holzer, P. Chiggiato, B. Dehning, G. Ferioli, V. Grishin, J. M. Jimenez, M. Taborelli, I. Wevers
    CERN, Geneva
  • A. Koshelev, A. Larionov, V. Seleznev, M. Sleptsov, A. Sytin
    IHEP Protvino, Protvino, Moscow Region
  • D. K. Kramer
    TUL, Liberec
 
  Beam-loss monitoring (BLM) is a key element in the LHC machine protection. 4250 nitrogen filled ionization chambers (IC) and 350 secondary emission monitors (SEM) have been manufactured at the Institute for High Energy Physics (IHEP) in Protvino, Russia, following their development at CERN. Signal speed and robustness against ageing were the main design criteria. Each monitor is permanently sealed inside a stainless-steel cylinder. The quality of the welding was a critical aspect during production. The SEMs are requested to hold a vacuum of 1·10-7 bar. Impurity levels from thermal and radiation-induced desorption should remain in the range of parts per million in the ICs. The difference in sensitivity is about 3·104. To avoid radiation aging (up to 2·108 Gy in 20 years) production of the chambers followed strict UHV requirements. IHEP designed and built the UHV production stand. Due to the required dynamic range of 1·109, the leakage current of the monitors has to stay below 1 pA. Several tests during and after production were performed at IHEP and CERN. A consistently high quality during the whole production period was achieved and the tight production schedule kept at the same time.