A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Calderaro, M.

Paper Title Page
MOPD003 ILC Cavity Fabrication Optimization for High Production 451
 
  • A. J. Favale, M. Calderaro, E. Peterson, J. J. Sredniawski
    AES, Medford, NY
 
  In 2006, AES performed a US based industrial Cost Study of RF units in production quantities sufficient for the ILC. During this study detailed costs were estimated for the fabrication steps of the SRF cavities in high production quantities. In late 2007, AES carried out a more detailed study specifically oriented toward optimizing the high production methods of only the SRF cavities to arrive at a best estimate of cost. We have found that the revised estimate shows a 34% reduction in cavity fabrication cost. We have optimized many of the machining and welding steps to take advantage of automated operations were possible. Our high production cost estimates were based upon actual machining, welding and parts handling times derived during the prototype fabrication of ILC type cavities at AES. These values were then applied with learning as appropriate to more automated operations to reduce labor costs. In addition, the type and size of e-beam welding machines was optimized. We found that the use of all single chamber welders covering three specific sizes was most cost effective. Details of steps leading to the stated conclusions are presented herein.