| Paper |
Title |
Page |
| TUPD027 |
Commissioning of the Offline-teststand for the S-DALINAC Polarized Injector SPIN
|
1482 |
| |
- C. Heßler, R. Barday, U. Bonnes, M. Brunken, C. Eckardt, R. Eichhorn, J. Enders, M. Platz, Y. Poltoratska, M. Roth
TU Darmstadt, Darmstadt
- W. Ackermann, W. F.O. Müller, B. Steiner, T. Weiland
TEMF, Darmstadt
- K. Aulenbacher
IKP, Mainz
|
|
| |
At the superconducting Darmstadt linear electron accelerator S-DALINAC a new injector for polarized electrons is under development. For this purpose an off-line test stand has been constructed. It consists of the source of polarized electrons and a test beamline including a Wien filter for spin manipulation, a Mott polarimeter for polarization measurement and various beam steering and diagnostic elements. The polarized electron beam is produced by photoemission from a strained GaAs cathode. We report on the status of this project and present first results of the measurements of the beam properties. We also give an outlook on the upcoming installation of SPIN at the S-DALINAC.
|
|
| WEPP091 |
Injector Upgrade for the S-DALINAC
|
2731 |
| |
- T. Kuerzeder, A. Araz, M. Brunken, J. Conrad, R. Eichhorn, H.-D. Gräf, M. Hertling, F. Hug, M. Konrad, M. Platz, A. Richter, S. Sievers, T. Weilbach
TU Darmstadt, Darmstadt
- W. Ackermann, W. F.O. Müller, B. Steiner, T. Weiland
TEMF, Darmstadt
- J. D. Fuerst
ANL, Argonne, Illinois
|
|
| |
Since 1991 the superconducting Darmstadt linear accelerator S-DALINAC provides an electron beam of up to 130 MeV for nuclear and astrophysical experiments. Currently its injector delivers beams of up to 10 MeV with a current of up to 60 μA. The upgrade aims to increase both parameters to 14 MeV and 150 μA in order to allow more demanding astrophysical experiments. Therefore, a modified cryostat module equipped with two new cavities is required. Due to an increase in RF power to 2 kW the old coaxial RF input couplers, being designed for a maximum power of 500 W, have to be replaced by new waveguide couplers. We review the design principles and report on the fabrication of the coupler and the whole module.
|
|