Paper |
Title |
Page |
WEPP039 |
Design of a 1036 cm-2 s-1 Super-B Factory
|
2605 |
|
- J. Seeman, K. J. Bertsche, A. Novokhatski, M. K. Sullivan, U. Wienands, W. Wittmer
SLAC, Menlo Park, California
- S. Bettoni
CERN, Geneva
- M. E. Biagini, R. Boni, M. Boscolo, T. Demma, A. Drago, S. Guiducci, P. Raimondi, S. Tomassini, M. Zobov
INFN/LNF, Frascati (Roma)
- A. Bogomyagkov, I. Koop, E. B. Levichev, S. A. Nikitin, P. A. Piminov, D. N. Shatilov
BINP SB RAS, Novosibirsk
- G. Marchiori
INFN-Pisa, Pisa
- E. Paoloni
University of Pisa and INFN, Pisa
|
|
|
Submitted for the High Luminosity Study Group for an Asymmetric Super-B-Factory: Parameters are being studied for a high luminosity e+e- collider operating at the Upsilon 4S that would deliver a luminosity of 1 to 2 x 1036/cm2/s. This collider would use a novel combination of linear collider and storage ring techniques. In this scheme an electron beam and a positron beam are stored in low-emittance damping rings similar to those designed for a Linear Collider (LC) or the next generation light source. A LC style interaction region is included in the ring to produce sub-millimeter vertical beta functions at the collision point. A large crossing angle (±25 mrad) is used at the collision point to allow beam separation. A crab-waist scheme is used to reduce the hourglass effect and restore peak luminosity. Beam currents of about 1.8 A in 1400 bunches can produce a luminosity of 1036/cm2/s with upgrade possibilities. Design parameters and beam dynamics effects are discussed.
|
|
WEPP040 |
New Low Emittance Lattices for the SuperB Accelerator Project
|
2608 |
|
- M. E. Biagini, M. Boscolo, P. Raimondi, S. Tomassini, M. Zobov
INFN/LNF, Frascati (Roma)
- S. Bettoni
CERN, Geneva
- A. Bogomyagkov, I. Koop, E. B. Levichev, S. A. Nikitin, P. A. Piminov, D. N. Shatilov
BINP SB RAS, Novosibirsk
- E. Paoloni
University of Pisa and INFN, Pisa
- J. Seeman, M. K. Sullivan, U. Wienands, W. Wittmer
SLAC, Menlo Park, California
|
|
|
New low emittance lattices (1.6 nm at 7 GeV, 2.8 nm at 4 GeV) have been designed for the asymmetric SuperB accelerator aiming at a luminosity of 1036 cm-2 s-1. Main optics features are two alternating arc cells with different horizontal phase advance, in order to decrease beam emittance and allow at the same time for easy chromaticity correction in the arcs. Emittance can be further reduced by a factor of two for luminosity upgrade. New beam parameters have been chosen to fulfill the transparency conditions for 4x7 GeV beams, different from the asymmetric currents used in operating B-Factories. Beam polarization schemes have been studied and will be implemented in the lattice.
|
|
WEPP046 |
Final Focus for the Crab-waist Tau-charm Factory
|
2623 |
|
- I. N. Okunev
BINP, Novosibirsk
- A. Bogomyagkov, E. B. Levichev, P. A. Piminov, S. V. Sinyatkin, P. Vobly
BINP SB RAS, Novosibirsk
|
|
|
In the crab-waist colliders design of the final focus region is a matter of primary importance. The paper describes analysis of final focus quadrupole design and results of particles tracking through the quadrupoles.
|
|