| Paper |
Title |
Page |
| TUPCH077 |
Beam Phase Measurement in a 200 MeV Cyclotron
|
1187 |
| |
- J.L. Conradie, A.H. Botha, P.J. Celliers, J.L.G. Delsink, D.T. Fourie, P.T. Mansfield, P.F. Rohwer, M.J. Van Niekerk
iThemba LABS, Somerset West
- J. Dietrich, I. Mohos
FZJ, Jülich
|
|
| |
New phase measuring equipment is being planned for the K 200 variable frequency, separated-sector cyclotron at iThemba LABS near Cape Town. A commercial lock-in amplifier is used to measure the beam phase over the full radial range. Measurements are made at the third and fifth harmonics of the main RF frequency to limit pick-up from the flat-topping and main dees. Computer-generated signals, with phase and amplitude control, at the same harmonics, are used to cancel the signals coupled from the dees to the phase probes. In addition the signals without beam are vectorially subtracted from those with beam to enhance the sensitivity and accuracy. Results of measurements, using these techniques, on existing phase probes in the cyclotron, will be presented.
|
|
| TUPCH080 |
Bunched Beam Current Measurements with 100 pA rms Resolution at CRYRING
|
1196 |
| |
- A. Paal, A. Simonsson
MSL, Stockholm
- J. Dietrich, I. Mohos
FZJ, Jülich
|
|
| |
In CRYRING molecular beams with currents down to 1 nA are used for experiments. To extend the rms resolution of the bunched beam current measurements down to 100 pA, a BERGOZ Integrating Current Transformer (ICT) and one of the the capacitive pick-up's sum signal are integrated simultaneously. The absolute calibration of the pick-up integrator signal is carried out at the end of the acceleration stage, during 20-60 ms. The ion beam current can be measured over a pulse width range of 100 ns to 15 us with a 20-60% bunch duty cycle. For both detectors, low noise amplifiers and a differential input double integrator have been designed. A programmable phase shifter allows measurement of the beam current during the acceleration of the ions, generating a gate signal with proper phase for the integrators in the 30 kHz-3 MHz frequency range. The bandwidth of the integrators used is 100 Hz.
|
|