| Paper |
Title |
Page |
| MOPCH112 |
The RAL Front End Test Stand
|
303 |
| |
- A.P. Letchford, M.A. Clarke-Gayther, D.C. Faircloth, D.C. Plostinar, J.K. Pozimski
CCLRC/RAL, Chilton, Didcot, Oxon
- J.J. Back
University of Warwick, Coventry
- Y.A. Cheng, S. Jolly, A. Kurup, P. Savage
Imperial College of Science and Technology, Department of Physics, London
|
|
| |
High power proton accelerators (HPPAs) with beam powers in the megawatt range have many possible applications including drivers for spallation neutron sources, neutrino factories, waste transmuters and tritium production facilities. These applications typically propose beam powers of 5 MW or more compared to the highest beam power achieved from a pulsed proton accelerator in routine operation of 0.16 MW at ISIS. The UK's commitment to the development of the next generation of HPPAs is demonstrated by a test stand being constructed in collaboration between RAL, Imperial College London and the University of Warwick. The aim of the RAL Front End Test Stand is to demonstrate that chopped low energy beams of high quality can be produced and is intended to allow generic experiments exploring a variety of operational regimes. This paper describes the status of the RAL Front End Test Stand which consists of five main components: a 60 mA H- ion source, a low energy beam transport, a 324 MHz Radio Frequency Quadrupole accelerator, a high speed beam chopper and a comprehensive suite of diagnostics. The aim is to demonstrate production of a 60 mA, 2 ms, 50 pps, chopped H- beam at 3 MeV.
|
|
| TUPLS090 |
LEBT Simulations and Ion Source Beam Measurements for the Front End Test Stand (FETS)
|
1714 |
| |
- S. Jolly, P. Savage
Imperial College of Science and Technology, Department of Physics, London
- J.J. Back
University of Warwick, Coventry
- D.C. Faircloth, A.P. Letchford
CCLRC/RAL/ISIS, Chilton, Didcot, Oxon
- J.K. Pozimski
CCLRC/RAL, Chilton, Didcot, Oxon
|
|
| |
The Front End Test Stand (FETS) at the Rutherford Appleton Laboratory (RAL) is intended to demonstrate the early stages of acceleration (0-3MeV) and beam chopping required for high power proton accelerators, including proton drivers for pulsed neutron spallation sources and neutrino factories. Optimisation of the beam focussing within the Low Energy Beam Transport (LEBT) is necessary to minimise beam losses upon acceleration within the FETS RadioFrequency Quadrupole (RFQ). Simulations of the LEBT are currently under way using the General Particle Tracer package (GPT). Previous envelope calculations suggest weak and strong focussing solutions for the LEBT solenoids. Definitive beam dynamics simulations in GPT require further measurements of the transverse emittances and beam profile of the ion source beam, due to the sensitivity of the simulations on the initial beam profile and level of space charge compensation. A pepperpot emittance/profile measurement system has been designed for use on the ISIS ion source development rig. Results from this pepperpot system are used to constrain the initial conditions for the GPT simulations.
|
|