| Paper |
Title |
Page |
| MOPCH190 |
Cryomodule Development for Superconducting RF Test Facility (STF) at KEK
|
505 |
| |
- K. Tsuchiya, H. Hayano, Y. Higashi, H. Hisamatsu, M. Masuzawa, H. Matsumoto, C. Mitsuda, S. Noguchi, N. Ohuchi, T. Okamura, K. Saito, A. Terashima, N. Toge
KEK, Ibaraki
|
|
| |
Current status of the cryomodule development for superconducting RF test facility, STF, at KEK is presented. The objective of the STF construction is to have an experience of 5-m long cryomodule fabrications and to learn an operational method of superconducting RF cavities. The STF consists of two 5-m long cryomodules, each housing four 9-cell cavities (one for 35 MV/m and the other for 45 MV/m). In addition to the cavity type, each cavity has variations in its appendices. Thus, two cryomodules must have different structures for the cavity support and for the port of the RF input coupler. This paper describes the details of the cryomodule design, the development of the bimetallic joint for connecting the titanium helium vessel to the stainless steel cooling pipe, and the studies of the magnetic shielding for high quality cavities.
|
|
| TUPCH179 |
R&D on Copper Beam Ducts with Antechambers and Related Vacuum Components
|
1438 |
| |
- Y. Suetsugu, H. Hisamatsu, K.-I. Kanazawa, K. Shibata, M. Shimamoto, M. Shirai
KEK, Ibaraki
|
|
| |
A beam duct with antechambers is able to reduce the effect of photoelectrons and, as a result, to suppress the electron cloud effect of positron or proton beam. It will be adopted for a future high current positron/proton rings and also a damping ring of a linear collider. Copper beam ducts with one or two antechambers were manufactured for test and the feasibility was studied. The test chambers were then installed into the KEK B-factory positron ring and the performance was investigated with a beam current up to 2000 mA. The temperature, the pressure and the electron density in the beam channel were measured during the beam operation. The photoelectron, for example, was found to be well suppressed as expected compared to that of a simple circular beam duct. The related vacuum components, such as a connection flange, a bellows chamber and a gate valve with the same cross section to the beam duct, were also developed and tested together with the beam duct.
|
|