PAC2013 - List of Authors (Savino, J.J.)

Paper

Title

Page

A Fast Rotating Wire Scanner for use in High Current Accelerators

385

S.J. Full, N.I. Agladze, A.C. Bartnik, I.V. Bazarov, J. Dobbins, B.M. Dunham, Y. Li, X. Liu, T.P. Moore, J.J. Savino, K.W. Smolenski
Cornell University (CLASSE), Cornell Laboratory for Accelerator-Based Sciences and Education, Ithaca, New York, USA

Funding: This work was supported by the financial assistance from the National Science Foundation (Grant No. DMR-0807731).}
We have developed a cost-effective, fast rotating wire scanner for use in accelerators where high beam currents would otherwise melt even carbon wires. This new design uses a simple planetary gear setup to rotate a carbon wire, fixed at one end, through the beam at speeds in excess of 20 m/s. We will present results from bench tests, as well as transverse beam profile measurements taken at Cornell's high-brightness ERL photoinjector, for a beam energy of 4 MeV and currents up to 35 mA.

Slides TUOBA1 [8.870 MB]

FRYBA1

Progress towards the Facility for Rare Isotope Beams

1453

J. Wei, N.K. Bultman, F. Casagrande, C. Compton, K.D. Davidson, J. DeKamp, B. Drewyor, K. Elliott, A. Facco, P.E. Gibson, T . Glasmacher, K. Holland, M.J. Johnson, S. Jones, D. Leitner, M. Leitner, G. Machicoane, F. Marti, D. Morris, J.A. Nolen, J.P. Ozelis, S. Peng, J. Popielarski, L. Popielarski, E. Pozdeyev, T. Russo, K. Saito, J.J. Savino, R.C. Webber, M. Williams, T. Xu, Y. Yamazaki, A. Zeller, Y. Zhang, Q. Zhao
FRIB, East Lansing, USA
D. Arenius, V. Ganni
JLAB, Newport News, Virginia, USA
A. Facco
INFN/LNL, Legnaro (PD), Italy
R.E. Laxdal
TRIUMF, Canada's National Laboratory for Particle and Nuclear Physics, Vancouver, Canada
J.A. Nolen
ANL, Argonne, USA

Funding: Work supported by the U.S. Department of Energy Office of Science under Cooperative Agreement DE-SC0000661
The Facility for Rare Isotope Beams (FRIB) is based on a continuous-wave superconducting heavy ion linac to accelerate all the stable isotopes to above 200 MeV/u with a beam power of up to 400 kW. At an average beam power approximately two-to-three orders-of-magnitude higher than those of operating heavy-ion facilities, FRIB stands at the power frontier of the accelerator family - the first time for heavy-ion accelerators. To realize this innovative performance, superconducting RF cavities are used starting at the very low energy of 500 keV/u, and beams with multiple charge states are accelerated simultaneously. Many technological challenges specific for this linac have been tackled by the FRIB team and collaborators. Furthermore, the distinct differences from the other types of linacs at the power front must be clearly understood to make the FRIB successful. This report summarizes the technical progress made in the past years to meet these challenges.

Paper	Title	Page
TUOBA1	A Fast Rotating Wire Scanner for use in High Current Accelerators	385
	S.J. Full, N.I. Agladze, A.C. Bartnik, I.V. Bazarov, J. Dobbins, B.M. Dunham, Y. Li, X. Liu, T.P. Moore, J.J. Savino, K.W. Smolenski Cornell University (CLASSE), Cornell Laboratory for Accelerator-Based Sciences and Education, Ithaca, New York, USA
	Funding: This work was supported by the financial assistance from the National Science Foundation (Grant No. DMR-0807731).} We have developed a cost-effective, fast rotating wire scanner for use in accelerators where high beam currents would otherwise melt even carbon wires. This new design uses a simple planetary gear setup to rotate a carbon wire, fixed at one end, through the beam at speeds in excess of 20 m/s. We will present results from bench tests, as well as transverse beam profile measurements taken at Cornell's high-brightness ERL photoinjector, for a beam energy of 4 MeV and currents up to 35 mA.
	Slides TUOBA1 [8.870 MB]

FRYBA1	Progress towards the Facility for Rare Isotope Beams	1453
	J. Wei, N.K. Bultman, F. Casagrande, C. Compton, K.D. Davidson, J. DeKamp, B. Drewyor, K. Elliott, A. Facco, P.E. Gibson, T . Glasmacher, K. Holland, M.J. Johnson, S. Jones, D. Leitner, M. Leitner, G. Machicoane, F. Marti, D. Morris, J.A. Nolen, J.P. Ozelis, S. Peng, J. Popielarski, L. Popielarski, E. Pozdeyev, T. Russo, K. Saito, J.J. Savino, R.C. Webber, M. Williams, T. Xu, Y. Yamazaki, A. Zeller, Y. Zhang, Q. Zhao FRIB, East Lansing, USA D. Arenius, V. Ganni JLAB, Newport News, Virginia, USA A. Facco INFN/LNL, Legnaro (PD), Italy R.E. Laxdal TRIUMF, Canada's National Laboratory for Particle and Nuclear Physics, Vancouver, Canada J.A. Nolen ANL, Argonne, USA
	Funding: Work supported by the U.S. Department of Energy Office of Science under Cooperative Agreement DE-SC0000661 The Facility for Rare Isotope Beams (FRIB) is based on a continuous-wave superconducting heavy ion linac to accelerate all the stable isotopes to above 200 MeV/u with a beam power of up to 400 kW. At an average beam power approximately two-to-three orders-of-magnitude higher than those of operating heavy-ion facilities, FRIB stands at the power frontier of the accelerator family - the first time for heavy-ion accelerators. To realize this innovative performance, superconducting RF cavities are used starting at the very low energy of 500 keV/u, and beams with multiple charge states are accelerated simultaneously. Many technological challenges specific for this linac have been tackled by the FRIB team and collaborators. Furthermore, the distinct differences from the other types of linacs at the power front must be clearly understood to make the FRIB successful. This report summarizes the technical progress made in the past years to meet these challenges.