2011 Particle Accelerator Conference - Classification: Accelerator Technology / Tech 09: Room Temperature Magnets

Paper

Title

Page

Introduction to HLSII Storage Ring Conventional Magnets

1100

H. Zhang, G. Feng, W.W. Li, W. Li, J.J. Liang, L. Wang, S.C. Zhang
USTC/NSRL, Hefei, Anhui, People's Republic of China

HLS (Hefei Light Source) is a dedicated synchrotron radiation research facility, whose emittance is relatively large. In order to improve the performance of HLS, especially getting higher brilliance synchrotron radiation and increasing the number of straight section for insertion devices, an upgrade project named HLSII will be proceeded soon. The storage ring lattice comprises 8 dipoles, 32 quadrupoles and 32 combined function sextupoles. Design and analysis of the magnets are showed in the paper. the multipurpose combined function magnet is the first one designed and used in China. Mechanical design and fabrication procedures for the magnets are presented also.

TUP146

Large Aperture Quadrupole Magnets for ISIS TS-1 and TS-2

1103

S.M. Gurov, A.M. Batrakov, M.F. Blinov, F.A. Emanov, V.V. Kobets, V.A. Polukhin, A.S. Tsyganov, P. Vobly, T.A. Yaskina
BINP SB RAS, Novosibirsk, Russia
S.J.S. Jago, J. Shih, S.F.S. Tomlinson
STFC/RAL/ISIS, Chilton, Didcot, Oxon, United Kingdom

The ISIS pulsed neutron and muon source at the Rutherford Appleton Laboratory has two target stations TS-1 and TS-2. Budker Institute of Nuclear Physics developed, produced and delivered seven type Q13 quadrupole magnets with an aperture diameter of 310 mm for TS-2 beam transfer line. Later an additional three quadrupoles with integrated dipole coils were developed and delivered to ISIS TS1. To improve the field quality across the full current range a special pole profile and end chamfer were designed using the MERMAID code. The magnetic field map was measured by a set of Hall probes. Moreover, BINP produced a rotating coil with radius 120 mm for field quality measurements.

TUP147

Rotating Dipole and Quadrupole Field for a Multiple Cathode System

1106

X. Chang, I. Ben-Zvi, J. Kewisch, V. Litvinenko, W. Meng, A.I. Pikin, V. Ptitsyn, T. Rao, B. Sheehy, J. Skaritka, Q. Wu
BNL, Upton, Long Island, New York, USA
E. Wang
PKU/IHIP, Beijing, People's Republic of China
T. Xin
Stony Brook University, Stony Brook, USA

A multiple cathode system has been designed to provide the high average current polarized electron bunches for the future electron-ion collider eRHIC. One of the key research topics in this design is the technique to generate a combined dipole and quadrupole rotating field at high frequency (700 kHz). This type of field is necessary for combining bunches from different cathodes to the same axis with minimum emittance growth. Our simulations and the prototype test results to achieve this will be presented.

TUP148

Ion Trapping Study in eRHIC

1109

Y. Hao, V. Litvinenko, V. Ptitsyn
BNL, Upton, Long Island, New York, USA

Funding: Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy.
The ion trapping effect is an important effect in energy recovery linac (ERL). The ionized residue gas molecules can accumulate at the vicinity of the electron beam pass and deteriorate the quality of the electron beam. In this paper, we present simulation results to address this issue in eRHIC and find best beam pattern to eliminate this effect.

TUP149

Magnetic Field Mapping and Integral Transfer Function Matching of the Prototype Dipoles for the NSLS-II at BNL

1112

P. He, M. Anerella, G. Ganetis, R.C. Gupta, A.K. Jain, P.N. Joshi, J. Skaritka, C.J. Spataro, P. Wanderer
BNL, Upton, Long Island, New York, USA

The National Synchrotron Light Source-II (NSLS-II) storage ring at Brookhaven National Laboratory (BNL) will be equipped with 54 dipole magnets having a gap of 35 mm, and 6 dipoles having a gap of 90 mm. The large aperture magnets are necessary to allow the extraction of long-wavelength light from the dipole magnet to serve a growing number of users of low energy radiation. The dipoles must not only have good field homogeneity (0.015% over a 40 mm x 20 mm region), but the integral transfer functions and integral end harmonics of the two types of magnets must also be matched. The 35 mm aperture dipole has a novel design where the yoke ends are extended up to the outside dimension of the coil using magnetic steel nose pieces. A Hall probe mapping system has been built with three Group 3 Hall probes mounted on a 2-D translation stage. The probes are arranged with one probe in the midplane of the magnet and the others vertically offset by ±10 mm. The field is mapped along a nominal 25 m radius beam trajectory. The results of measurements in the as-received magnets, and with modifications made to the nose pieces will be presented.

TUP152

Dipole Corrector Magnets for the LBNE Beam Line

1115

M. Yu, D.J. Harding, G. Velev
Fermilab, Batavia, USA

The conceptual design of a new dipole corrector magnet has been thoroughly studied. The planned Long-Baseline Neutrino Experiment (LBNE) beam line will require correctors capable of greater range and linearity than existing correctors, so a new design is proposed based on the horizontal trim dipole correctors built for the Main Injector synchrotron at Fermilab. The gap, pole shape, length, and number of conductor turns remain the same. To allow operation over a wider range of excitations without overheating, the conductor size is increased, and to maintain better linearity, the back leg thickness is increased. The magnetic simulation was done using ANSYS to optimize the shape and the size of the yoke. The thermal performance was also modeled and analyzed.

THOBS2

Optimization of Magnet Stability and Alignment for NSLS-II

2082

S.K. Sharma, L. Doom, A.K. Jain, P.N. Joshi, F. Lincoln, V. Ravindranath
BNL, Upton, Long Island, New York, USA

Funding: This work was supported by Department of Energy contract DE-AC02-98CH10886
The high-brightness design of NSLS-II requires uncorrelated vertical RMS motion of the multipole magnets on a girder to be less than 25 nm. Also, the highly nonlinear lattice requires alignment of the multipole magnets to 30 microns. The speaker will describe the stability of the girder-magnets assembly and the factors affecting it, such as ambient ground motion and temperature fluctuations in the storage ring. Technical solutions to achieve the desired stability will be presented as well.

Slides THOBS2 [4.431 MB]

Paper	Title	Page
TUP145	Introduction to HLSII Storage Ring Conventional Magnets	1100
	H. Zhang, G. Feng, W.W. Li, W. Li, J.J. Liang, L. Wang, S.C. Zhang USTC/NSRL, Hefei, Anhui, People's Republic of China
	HLS (Hefei Light Source) is a dedicated synchrotron radiation research facility, whose emittance is relatively large. In order to improve the performance of HLS, especially getting higher brilliance synchrotron radiation and increasing the number of straight section for insertion devices, an upgrade project named HLSII will be proceeded soon. The storage ring lattice comprises 8 dipoles, 32 quadrupoles and 32 combined function sextupoles. Design and analysis of the magnets are showed in the paper. the multipurpose combined function magnet is the first one designed and used in China. Mechanical design and fabrication procedures for the magnets are presented also.

TUP146	Large Aperture Quadrupole Magnets for ISIS TS-1 and TS-2	1103
	S.M. Gurov, A.M. Batrakov, M.F. Blinov, F.A. Emanov, V.V. Kobets, V.A. Polukhin, A.S. Tsyganov, P. Vobly, T.A. Yaskina BINP SB RAS, Novosibirsk, Russia S.J.S. Jago, J. Shih, S.F.S. Tomlinson STFC/RAL/ISIS, Chilton, Didcot, Oxon, United Kingdom
	The ISIS pulsed neutron and muon source at the Rutherford Appleton Laboratory has two target stations TS-1 and TS-2. Budker Institute of Nuclear Physics developed, produced and delivered seven type Q13 quadrupole magnets with an aperture diameter of 310 mm for TS-2 beam transfer line. Later an additional three quadrupoles with integrated dipole coils were developed and delivered to ISIS TS1. To improve the field quality across the full current range a special pole profile and end chamfer were designed using the MERMAID code. The magnetic field map was measured by a set of Hall probes. Moreover, BINP produced a rotating coil with radius 120 mm for field quality measurements.

TUP147	Rotating Dipole and Quadrupole Field for a Multiple Cathode System	1106
	X. Chang, I. Ben-Zvi, J. Kewisch, V. Litvinenko, W. Meng, A.I. Pikin, V. Ptitsyn, T. Rao, B. Sheehy, J. Skaritka, Q. Wu BNL, Upton, Long Island, New York, USA E. Wang PKU/IHIP, Beijing, People's Republic of China T. Xin Stony Brook University, Stony Brook, USA
	A multiple cathode system has been designed to provide the high average current polarized electron bunches for the future electron-ion collider eRHIC. One of the key research topics in this design is the technique to generate a combined dipole and quadrupole rotating field at high frequency (700 kHz). This type of field is necessary for combining bunches from different cathodes to the same axis with minimum emittance growth. Our simulations and the prototype test results to achieve this will be presented.

TUP148	Ion Trapping Study in eRHIC	1109
	Y. Hao, V. Litvinenko, V. Ptitsyn BNL, Upton, Long Island, New York, USA
	Funding: Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy. The ion trapping effect is an important effect in energy recovery linac (ERL). The ionized residue gas molecules can accumulate at the vicinity of the electron beam pass and deteriorate the quality of the electron beam. In this paper, we present simulation results to address this issue in eRHIC and find best beam pattern to eliminate this effect.

TUP149	Magnetic Field Mapping and Integral Transfer Function Matching of the Prototype Dipoles for the NSLS-II at BNL	1112
	P. He, M. Anerella, G. Ganetis, R.C. Gupta, A.K. Jain, P.N. Joshi, J. Skaritka, C.J. Spataro, P. Wanderer BNL, Upton, Long Island, New York, USA
	The National Synchrotron Light Source-II (NSLS-II) storage ring at Brookhaven National Laboratory (BNL) will be equipped with 54 dipole magnets having a gap of 35 mm, and 6 dipoles having a gap of 90 mm. The large aperture magnets are necessary to allow the extraction of long-wavelength light from the dipole magnet to serve a growing number of users of low energy radiation. The dipoles must not only have good field homogeneity (0.015% over a 40 mm x 20 mm region), but the integral transfer functions and integral end harmonics of the two types of magnets must also be matched. The 35 mm aperture dipole has a novel design where the yoke ends are extended up to the outside dimension of the coil using magnetic steel nose pieces. A Hall probe mapping system has been built with three Group 3 Hall probes mounted on a 2-D translation stage. The probes are arranged with one probe in the midplane of the magnet and the others vertically offset by ±10 mm. The field is mapped along a nominal 25 m radius beam trajectory. The results of measurements in the as-received magnets, and with modifications made to the nose pieces will be presented.

TUP152	Dipole Corrector Magnets for the LBNE Beam Line	1115
	M. Yu, D.J. Harding, G. Velev Fermilab, Batavia, USA
	The conceptual design of a new dipole corrector magnet has been thoroughly studied. The planned Long-Baseline Neutrino Experiment (LBNE) beam line will require correctors capable of greater range and linearity than existing correctors, so a new design is proposed based on the horizontal trim dipole correctors built for the Main Injector synchrotron at Fermilab. The gap, pole shape, length, and number of conductor turns remain the same. To allow operation over a wider range of excitations without overheating, the conductor size is increased, and to maintain better linearity, the back leg thickness is increased. The magnetic simulation was done using ANSYS to optimize the shape and the size of the yoke. The thermal performance was also modeled and analyzed.

THOBS2	Optimization of Magnet Stability and Alignment for NSLS-II	2082
	S.K. Sharma, L. Doom, A.K. Jain, P.N. Joshi, F. Lincoln, V. Ravindranath BNL, Upton, Long Island, New York, USA
	Funding: This work was supported by Department of Energy contract DE-AC02-98CH10886 The high-brightness design of NSLS-II requires uncorrelated vertical RMS motion of the multipole magnets on a girder to be less than 25 nm. Also, the highly nonlinear lattice requires alignment of the multipole magnets to 30 microns. The speaker will describe the stability of the girder-magnets assembly and the factors affecting it, such as ambient ground motion and temperature fluctuations in the storage ring. Technical solutions to achieve the desired stability will be presented as well.
	Slides THOBS2 [4.431 MB]