BNL, Upton, Long Island, New York, USA
The commissioning of the RHIC spin flipper in the RHIC Blue ring during the RHIC polarized proton run in 2009 showed the detrimental effects of global vertical coherent betatron oscillation induced by the 2-AC dipole plus 4-DC dipole configuration *. Additional three AC dipoles were added to the RHIC spin flipper in the RHIC Blue ring during the summer of 2010 to eliminate the vertical coherent betatron oscillations outside the spin flipper [2]. This new design is scheduled to be commissioned during the RHIC polarized proton run in 2011. This paper presents the status of the system as well as latest simulation results.
* M. Bai , T. Roser, C. Dawson, Y. Makdisi, W. Meng, F. Meot, P. Oddo, C. Pai, P. Pile, RHIC Spin Flipper New Design and Commissioning Plan, IPAC10 proceedings, IPAC 2010, Kyoto, Japan, 2010
BNL, Upton, Long Island, New York, USA
The RHIC Spin Flipper's five high-Q AC dipoles which are driven by a swept frequency waveform require precise control of phase and amplitude during the sweep. This control is achieved using FPGA based feedback controllers. Multiple feedback loops are used to control and dynamically tune the magnets. The current implementation and results will be presented.
BNL, Upton, Long Island, New York, USA
A high performance FPGA based platform has been developed for the RHIC Low Level RF system upgrade, and is now replacing our aging VME based systems. This new platform employs a sophisticated embedded architecture to implement its core functionality. This architecture provides a control system interface, manages remote access to all configuration parameters and diagnostic data, supports communication between all system components, enables real time application specific processing, monitors system health, etc. This paper will describe the embedded architecture and its capabilities, with emphasis on its application at RHIC.
BNL, Upton, Long Island, New York, USA
JLAB, Newport News, Virginia, USA
All physics stores at the Relativistic Heavy Ion Collider are now established using simultaneous orbit, tune, coupling, and energy feedback during beam injection, acceleration to full beam energies, during the “beta-squeeze” for establishing small beam sizes at the interaction points, and during removal of separation bumps to establish collisions. In this report we describe the major changes made to enable these achievements. The proof-of-principle for additional chromaticity feedback will also be presented.
