2011 Particle Accelerator Conference - List of Authors (He, P.)

Paper

Title

Page

Magnetic Field Mapping and Integral Transfer Function Matching of the Prototype Dipoles for the NSLS-II at BNL

1112

P. He, M. Anerella, G. Ganetis, R.C. Gupta, A.K. Jain, P.N. Joshi, J. Skaritka, C.J. Spataro, P. Wanderer
BNL, Upton, Long Island, New York, USA

The National Synchrotron Light Source-II (NSLS-II) storage ring at Brookhaven National Laboratory (BNL) will be equipped with 54 dipole magnets having a gap of 35 mm, and 6 dipoles having a gap of 90 mm. The large aperture magnets are necessary to allow the extraction of long-wavelength light from the dipole magnet to serve a growing number of users of low energy radiation. The dipoles must not only have good field homogeneity (0.015% over a 40 mm x 20 mm region), but the integral transfer functions and integral end harmonics of the two types of magnets must also be matched. The 35 mm aperture dipole has a novel design where the yoke ends are extended up to the outside dimension of the coil using magnetic steel nose pieces. A Hall probe mapping system has been built with three Group 3 Hall probes mounted on a 2-D translation stage. The probes are arranged with one probe in the midplane of the magnet and the others vertically offset by ±10 mm. The field is mapped along a nominal 25 m radius beam trajectory. The results of measurements in the as-received magnets, and with modifications made to the nose pieces will be presented.

THOBS4

Current Status of Insertion Device Development at the NSLS-II and its Future Plans

2090

T. Tanabe, O.V. Chubar, T.M. Corwin, D.A. Harder, P. He, C.A. Kitegi, G. Rakowsky, J. Rank, C. Rhein, C.J. Spataro
BNL, Upton, Long Island, New York, USA

Funding: This manuscript has been authored by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH1-886 with the U.S. Department of Energy.
National Synchrotron Light Source-II (NSLS-II) project is currently under construction. Procurement of various insertion devices (IDs) has begun. IDs in the project baseline scope include six 3.5m long damping wigglers (DWs) with 100mm period, two 2.0m Elliptically Polarizing Undulator (EPU) with 49mm period, two 3.0m-20mm period IVUs and one 1.5m-21mm IVU. Recently a special device for inelastic X-ray scattering beamline has been added to the collection of baseline devices. This is a special wide pole IVU with 22mm period for a long straight section. Three pole wigglers with 28mm gap and peak field over 1T will be utilized for NSLS bending magnet users. Examples of R&D work for future devices are: 1) Development of in-vacuum magnetic measurement system (IVMMS), 2) Use of new type of magnet such as PrFeB for improved performance on cryo-permanent magnet undulator (CPMU), 3) Development of closed loop He gas refrigerator with a linear motor actuator, 4) Adaptive gap undulator (AGU) 5) Various field measurement technique improvement. Design features of the baseline devices, ID-Magnetic Measurement Facility and the future plans for NSLS-II ID activities are described.

Slides THOBS4 [4.171 MB]

TUOAN2

High Luminosity Electron-Hadron Collider eRHIC

693

V. Ptitsyn, E.C. Aschenauer, M. Bai, J. Beebe-Wang, S.A. Belomestnykh, I. Ben-Zvi, M. Blaskiewicz, R. Calaga, X. Chang, A.V. Fedotov, H. Hahn, L.R. Hammons, Y. Hao, P. He, W.A. Jackson, A.K. Jain, E.C. Johnson, D. Kayran, J. Kewisch, V. Litvinenko, G.J. Mahler, G.T. McIntyre, W. Meng, M.G. Minty, B. Parker, A.I. Pikin, T. Rao, T. Roser, B. Sheehy, J. Skaritka, S. Tepikian, R. Than, D. Trbojevic, N. Tsoupas, J.E. Tuozzolo, G. Wang, Q. Wu, W. Xu, A. Zelenski
BNL, Upton, Long Island, New York, USA
E. Pozdeyev
FRIB, East Lansing, Michigan, USA
E. Tsentalovich
MIT, Middleton, Massachusetts, USA

Funding: Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy.
We present the design of future high-energy high-luminosity electron-hadron collider at RHIC called eRHIC. We plan on adding 20 (potentially 30) GeV energy recovery linacs to accelerate and to collide polarized and unpolarized electrons with hadrons in RHIC. The center-of-mass energy of eRHIC will range from 30 to 200 GeV. The luminosity exceeding 10³⁴ cm^-2 s^-1 can be achieved in eRHIC using the low-beta interaction region with a 10 mrad crab crossing. We report on the progress of important eRHIC R&D such as the high-current polarized electron source, the coherent electron cooling and the compact magnets for recirculating passes. A natural staging scenario of step-by-step increases of the electron beam energy by builiding-up of eRHIC's SRF linacs and a potential of adding polarized positrons are also presented.

Slides TUOAN2 [4.244 MB]

Paper	Title	Page
TUP149	Magnetic Field Mapping and Integral Transfer Function Matching of the Prototype Dipoles for the NSLS-II at BNL	1112
	P. He, M. Anerella, G. Ganetis, R.C. Gupta, A.K. Jain, P.N. Joshi, J. Skaritka, C.J. Spataro, P. Wanderer BNL, Upton, Long Island, New York, USA
	The National Synchrotron Light Source-II (NSLS-II) storage ring at Brookhaven National Laboratory (BNL) will be equipped with 54 dipole magnets having a gap of 35 mm, and 6 dipoles having a gap of 90 mm. The large aperture magnets are necessary to allow the extraction of long-wavelength light from the dipole magnet to serve a growing number of users of low energy radiation. The dipoles must not only have good field homogeneity (0.015% over a 40 mm x 20 mm region), but the integral transfer functions and integral end harmonics of the two types of magnets must also be matched. The 35 mm aperture dipole has a novel design where the yoke ends are extended up to the outside dimension of the coil using magnetic steel nose pieces. A Hall probe mapping system has been built with three Group 3 Hall probes mounted on a 2-D translation stage. The probes are arranged with one probe in the midplane of the magnet and the others vertically offset by ±10 mm. The field is mapped along a nominal 25 m radius beam trajectory. The results of measurements in the as-received magnets, and with modifications made to the nose pieces will be presented.

THOBS4	Current Status of Insertion Device Development at the NSLS-II and its Future Plans	2090
	T. Tanabe, O.V. Chubar, T.M. Corwin, D.A. Harder, P. He, C.A. Kitegi, G. Rakowsky, J. Rank, C. Rhein, C.J. Spataro BNL, Upton, Long Island, New York, USA
	Funding: This manuscript has been authored by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH1-886 with the U.S. Department of Energy. National Synchrotron Light Source-II (NSLS-II) project is currently under construction. Procurement of various insertion devices (IDs) has begun. IDs in the project baseline scope include six 3.5m long damping wigglers (DWs) with 100mm period, two 2.0m Elliptically Polarizing Undulator (EPU) with 49mm period, two 3.0m-20mm period IVUs and one 1.5m-21mm IVU. Recently a special device for inelastic X-ray scattering beamline has been added to the collection of baseline devices. This is a special wide pole IVU with 22mm period for a long straight section. Three pole wigglers with 28mm gap and peak field over 1T will be utilized for NSLS bending magnet users. Examples of R&D work for future devices are: 1) Development of in-vacuum magnetic measurement system (IVMMS), 2) Use of new type of magnet such as PrFeB for improved performance on cryo-permanent magnet undulator (CPMU), 3) Development of closed loop He gas refrigerator with a linear motor actuator, 4) Adaptive gap undulator (AGU) 5) Various field measurement technique improvement. Design features of the baseline devices, ID-Magnetic Measurement Facility and the future plans for NSLS-II ID activities are described.
	Slides THOBS4 [4.171 MB]

TUOAN2	High Luminosity Electron-Hadron Collider eRHIC	693
	V. Ptitsyn, E.C. Aschenauer, M. Bai, J. Beebe-Wang, S.A. Belomestnykh, I. Ben-Zvi, M. Blaskiewicz, R. Calaga, X. Chang, A.V. Fedotov, H. Hahn, L.R. Hammons, Y. Hao, P. He, W.A. Jackson, A.K. Jain, E.C. Johnson, D. Kayran, J. Kewisch, V. Litvinenko, G.J. Mahler, G.T. McIntyre, W. Meng, M.G. Minty, B. Parker, A.I. Pikin, T. Rao, T. Roser, B. Sheehy, J. Skaritka, S. Tepikian, R. Than, D. Trbojevic, N. Tsoupas, J.E. Tuozzolo, G. Wang, Q. Wu, W. Xu, A. Zelenski BNL, Upton, Long Island, New York, USA E. Pozdeyev FRIB, East Lansing, Michigan, USA E. Tsentalovich MIT, Middleton, Massachusetts, USA
	Funding: Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy. We present the design of future high-energy high-luminosity electron-hadron collider at RHIC called eRHIC. We plan on adding 20 (potentially 30) GeV energy recovery linacs to accelerate and to collide polarized and unpolarized electrons with hadrons in RHIC. The center-of-mass energy of eRHIC will range from 30 to 200 GeV. The luminosity exceeding 10³⁴ cm^-2 s^-1 can be achieved in eRHIC using the low-beta interaction region with a 10 mrad crab crossing. We report on the progress of important eRHIC R&D such as the high-current polarized electron source, the coherent electron cooling and the compact magnets for recirculating passes. A natural staging scenario of step-by-step increases of the electron beam energy by builiding-up of eRHIC's SRF linacs and a potential of adding polarized positrons are also presented.
	Slides TUOAN2 [4.244 MB]