BNL, Upton, Long Island, New York
TUB, Beijing
There is a growing interest in optimizing the electron beam for an X-ray Free Electron Laser (FEL) in the low charge (10 to 200 pC) and femto-seconds regimes. We have experimentally demonstrated sub-picosecond high-brightness electron beam for a 40 pC charge with ballistic bunch compression and a reduced laser spot size*. Simulation studies showed the feasibility of generating 10 femto-seconds kilo-ampere electron beam with a 20 pC charge**. This paper reports the progress of experimental demonstration of a femto-seconds kilo-ampere electron beam at the NSLS Source Development Lab (SDL). The femto-seconds kilo-ampere electron beam will be used to drive a self-amplified spontaneous emission (SASE) FEL, and SASE FEL spectra and pulse length will be used to measure the electron beam bunch length. The transverse properties of the electron beam will also be experimentally characterized.
*X.J. Wang, et al, Phys. Rev. E , 54, No.4, R3121 -3124 (1996).
**X.J. Wang and X.Y. Chang, Nuclear Instruments and Methods in Physics Research A 507, 310313 (2003)
TUB, Beijing
BNL, Upton, Long Island, New York
Funding: Supported by National Natural Science Foundation of China (No.10735050, No.10875070) and National Basic Research Program of China (973 Program)(No.2007CB815102)
Time-resolved MeV ultra-fast electron diffraction (UED) is a promising tool for studying of structural dynamics on the fundamental temporal and spatial scales of atomic motion. To reach the desired temporal and spatial resolutions, precise control and measurement of ultra-short, low emittance electron pulses are required. A MeV UED system based on an S-band photocathode RF gun is built and optimized at Tsinghua University. We present the experiment results here.
TUB, Beijing
The preliminary experiments and three-dimensional (3D) particle-in-cell (PIC) simulations of terahertz (THz) coherent transition radiation (CTR) performed at the Accelerator Laboratory of Tsinghua University are reported in this paper. THz radiation is generated from the interactions of Titanium foil with the ultrashort electron beam produced by the photocathode RF gun. The frequency and power of radiation are measured with the Martin-Pupllet interferometer and Gollay Cell detector, respectively. The radiation characteristics depending on the foil properties are preliminarily studied with the experiments and PIC simulations. On the other hand, the distribution of radiation field pattern and energy are studied by numerical calculated, and those results are in agreement with the PIC simulations.
TUB, Beijing
IHEP Beijing, Beijing
CIAE, Beijing
ANL, Argonne
KEK, Tsukuba
Funding: Supported by the “985 Project” of the Minister of Education of China, CAS Bairen Init. (KJCX2-YW-N22), CAS Overseas Outstanding Youth Program, and the National Natural Science Foundation (10628510).
During the past decades, large-scale national neutron sources are developed in Asia, Europe, and USA. Complementing such efforts, compact hadron beam complexes and neutron sources intended for universities and industrial institutes are proposed and established. Responding to the demands in China for multidisciplinary researches and applications using pulsed neutrons and protons, hadron therapy and radiography, and accelerator-driven sub-critical reactor systems (ADS) for nuclear waste transmutation, we here propose a compact yet expandable accelerator complex based on a proton source, a 3 MeV RFQ linac, and a 22 MeV DTL linac. A Be target with solid methane and room-temperature water moderators serve 6 neutron stations for imaging/radiography, irradiation, SANS, engineering powder diffraction, instrumentation, and therapy. The proton platform serves multiple stations for bio-applications, fuel cell and nano-applications, and space irradiation and detection. A rapid cycling synchrotron subsequently accelerates the beam to up to 300 MeV for proton therapy and radiography. Following the DTL linac with a superconducting RF linac and a sub-critical reactor offers an ADS test facility.
TUB, Beijing
Funding: This work is supported by National Natural Science Foundation of China(Project 10735050) and National Basic Research Program of China (973 Program)(Grant No. 2007CB815102).
The X-band photocathode RF gun can be utilized to generate electron beams with ultra-low emittance. In this paper, we present the design of a coaxial coupler for the X-band RF gun to avoid the emittance growth caused by field asymmetries. A detailed 3D simulation of the coupler is performed. The microwave circuit analysis is accomplished, and the relationship between the coupling factor and the coaxial coupler size is obtained. This paper likewise presents the beam dynamics parameters of the X-band RF gun with a coaxial coupler.
TUB, Beijing
LBNL, Berkeley, California
Funding: Supported by National Natural Science Foundation of China (No.10775080)
An S-band RF deflecting cavity has been developed and applied for measuring the bunch length at Tsinghua Thomson-Scattering X-ray Source (TTX). This paper briefly introduces the 3-cell pi-mode standing-wave deflecting cavity and reports the recent experiments of the beam diagnostics for the photo-cathode RF gun, which produces electron bunches with RMS length around 1-ps. It is also observed that the bunches are lengthened while the total charge increases, showing the strong space charge effect at a low beam energy.
TUB, Beijing
BNL, Upton, Long Island, New York
Synchronization between a laser system and an electron beam plays a critical role in photoinjector operation, pump-probe experiments and many other applications. Here we report two novel experimental techniques for measuring the laser to RF timing jitter in a photoinjector, and e-beam arrival timing jitter after a magnetic chicane bunch compressor. The laser to RF timing jitter was characterized by observing the electron beam charge fluctuation through the Schottky effect. This technique was used to characterize the SDL photoinjector laser to RF timing jitter as a function of the temperature fluctuation in the laser room, and we have shown the resolution of this technique is ~100 fs. A stripline beam position monitor (BPM) located down stream of the compressor will be used to investigate the e-beam arrival timing jitter after a magnetic chicane bunch compressor; the outputs of the stripline BPM can be used to measure the arrival timing jitter by mixing them with a RF reference signal. The effect of the chicane on the arrival time jitters will be studied for the first time using this technique.
TUB, Beijing
Funding: This work is supported by National Natural Science Foundation of China (Project 10735050) and National Basic Research Program of China (973 Program) (Grant No. 2007CB815102).
The feasibility study of optical stochastic cooling (OSC) utilizing a compact storage ring is presented in this paper. We present the general layout of the scheme, as well as the lattice design of the storage ring. The results of beam dynamics simulation are likewise presented.
TUB, Beijing
The Multipactor Electron Gun (MEG) can produce high current self-bunching electron beams. In this paper, the primary experimental results of an S-band MEG based accelerator are presented. The accelerator was modified from a 6MeV standing wave accelerator to integrate the MEG, which has an adjusting structure to control both the cathode-grid distance and frequency tuner. The designed output energy is 5MeV and average current is 100mA. The experiment included low power microwave parameter measurement and high power beam test. In the microwave parameter measurement, the relationship between tuner position and E-field distribution was investigated. Platinum was used as the secondary electron emitters of the MEG. The multipacting process was observed and an average current of 40mA was collected by an aluminum target.
CAEP/IFP, Mainyang, Sichuan
TUB, Beijing
CAEP/IAE, Mianyang, Sichuan
It has been three decades since the research and development of key technologies and components started at the Institute of Fluid Physics, CAEP, for the linear induction accelerator (LIA). The first LIA was built in 1989 with beam parameters of 1.5 MeV, 3 kA and pulse width of 90 ns. Later the SG-I LIA (3.3 MeV, 2 kA, 90 ns) was developed for FEL in 1991. The first Linear Induction Accelerator X-Ray Facility (LIAXF, 10 MeV, 2 kA, 90 ns, spot size about 6 mm in diameter) was built in 1993 and upgraded to 12 MeV with higher performance (LIAXFU, 12 MeV, 2.5 kA, 90 ns, spot size about 4 mm in diameter) in 1995. The Dragon-I LIA with the best quality (20 MeV, 2.5 kA, 80 ns, spot size about 1 mm in diameter) in the world was finished in 2003. The smallest LIA with double pulses separated by 300 ns (MiniLIA, 200 keV, 1 A, 80 ns) was developed in 2007 for beam physics studies.
