A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Pietryla, A.F.

Paper Title Page
TUP043 Development of a Beam Loss Monitor System for the LCLS Undulator Beamline 492
 
  • W. Berg, J.C. Dooling, A.F. Pietryla, B.X. Yang
    ANL, Argonne
  • H.-D. Nuhn
    SLAC, Menlo Park, California
 
 

Funding: Work Argonne supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under contract number DE-AC02-06CH11357.
A Beam-Loss Monitor (BLM) system based on the detection of Cerenkov radiation is in development at the Advanced Photon Source (APS) for the Linac Coherent Light Source (LCLS) free-electron laser. The electron beam will vary in energy nominally from 4 to 14 GeV with a beam charge of 0.2 to 1.0 nC and a maximum repetition rate of 120 Hz. To limit radiation-induced demagnetization of the undulator permanent magnets, the BLM will provide beam-loss threshold detection as part of the Machine Protection System (MPS). The detector incorporates a large volume (30 cc) fused silica Cerenkov radiator coupled to a photomultiplier tube (PMT). The output of the PMT is conditioned locally by a charge amplifier circuit and then digitized at the front end of the MPS rack electronics. During commissioning, the device will be calibrated by inserting a 1-micron aluminum foil into the beam, upstream of the undulator magnets. The present design calls for five BLM detector units to be distributed throughout the 33 undulator magnets. Beam-based testing is to begin at the APS storage ring during the summer of 2008. Details and status of the detector hardware, electronics, and simulations will be discussed.