IPAC2015 - List of Authors (Potratz, C.)

Paper	Title	Page
MOPWA018	Loss Factor and Impedance Analysis of Warm Components of BERLinPro	128
	H.-W. Glock, M. Abo-Bakr, J. Kolbe, F. Pflocksch, A. Schälicke HZB, Berlin, Germany H.-W. Glock, C. Potratz COMPAEC e.G., Rostock, Germany
	Funding: Work supported by German Bundesministerium für Bildung und Forschung, Land Berlin, and grants of Helmholtz Association The ongoing component design for the HZB 50 MeV, 100mA ERL project BERLinPro is accompanied by loss factor and impedance computations. A list of accelerator components including bellows, collimators, tapers, shutter valves etc. is given, some of them with alternative shapes. Loss factors, calculated using CSTParticleStudio®, are presented together with important properties of the impedance spectrum. Scaling of the loss factors with respect to bunch length is calculated on base of the numerical simulations and is used to extrapolate down to a bunch length (1 standard deviation) of 0.6 mm, which is hard to reach directly in numerical simulations.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2015-MOPWA018
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Loss Factor and Impedance Analysis of Warm Components of BERLinPro

128

H.-W. Glock, M. Abo-Bakr, J. Kolbe, F. Pflocksch, A. Schälicke
HZB, Berlin, Germany
H.-W. Glock, C. Potratz
COMPAEC e.G., Rostock, Germany

Funding: Work supported by German Bundesministerium für Bildung und Forschung, Land Berlin, and grants of Helmholtz Association
The ongoing component design for the HZB 50 MeV, 100mA ERL project BERLinPro is accompanied by loss factor and impedance computations. A list of accelerator components including bellows, collimators, tapers, shutter valves etc. is given, some of them with alternative shapes. Loss factors, calculated using CSTParticleStudio®, are presented together with important properties of the impedance spectrum. Scaling of the loss factors with respect to bunch length is calculated on base of the numerical simulations and is used to extrapolate down to a bunch length (1 standard deviation) of 0.6 mm, which is hard to reach directly in numerical simulations.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2015-MOPWA018

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)