Author: Kubo, T.
Paper Title Page
WEPWO014 Rf Field-Attenuation Formulae for the Multilayer Coating Model 2343
 
  • T. Kubo, T. Saeki
    KEK, Ibaraki, Japan
  • Y. Iwashita
    Kyoto ICR, Uji, Kyoto, Japan
 
  Formulae that describe the RF electromagnetic field attenuation in the multilayer coating model with a single superconductor layer and a single insulator layer deposited on a bulk superconductor are derived with a rigorous calculation based on the Maxwell equations and the London equation.  
 
WEPWO015 Electron Beam Welding for High Gradient Superconducting Cavity 2346
 
  • T. Kubo, Y. Ajima, H. Hayano, H. Inoue, S. Kato, T. Saeki, M. Sawabe, K. Umemori, Y. Watanabe, S. Yamaguchi, M. Yamanaka
    KEK, Ibaraki, Japan
  • Y. Iwashita
    Kyoto ICR, Uji, Kyoto, Japan
  • T. Nagata
    ULVAC, Inc., Tsukuba, Japan
 
  Relations between electron beam welding parameters and appearances of weld beads are studied. It was found that a beam generator position and a welding direction affect a geometry of weld bead dramatically. Carbon including contaminants found after the chemistry are also commented.  
 
THOBB203 Study on Fabrication of Superconducting RF 9-cell Cavity for ILC at KEK 3132
 
  • T. Saeki, Y. Ajima, K. Enami, H. Hayano, H. Inoue, E. Kako, S. Kato, S. Koike, T. Kubo, S. Noguchi, M. Satoh, M. Sawabe, T. Shishido, A. Terashima, N. Toge, K. Ueno, K. Umemori, K. Watanabe, Y. Watanabe, S. Yamaguchi, A. Yamamoto, Y. Yamamoto, M. Yamanaka, K. Yokoya
    KEK, Ibaraki, Japan
  • Y. Iwashita
    Kyoto ICR, Uji, Kyoto, Japan
  • N. Kawabata, H. Nakamura, K. Nohara, M. Shinohara
    SPS, Funabashi-shi, Japan
  • F. Yasuda
    The University of Tokyo, Institute of Physics, Tokyo, Japan
 
  We constructed a new facility for the fabrication of superconducting RF cavity at KEK from 2009 to 2011. In the facility, we have installed a deep-drawing machine, a half-cell trimming machine, an electron-beam welding machine, and a chemical etching room in one place. We started the study on the fabrication of 9-cell cavity for International Linear Collier (ILC) from 2009 using this facility. The study is focusing on the cost reduction with keeping high performance of cavity, and the goal is the establishment of mass-production procedure for ILC. This article reports the current status of the studies in CFF.  
slides icon Slides THOBB203 [3.983 MB]