Author: Kang, T.-H.
Paper Title Page
WEODB103 Current Status of PAL-XFEL Project 2074
 
  • H.-S. Kang, J.H. Han, T.-H. Kang, C. Kim, D.E. Kim, S.H. Kim, I.S. Ko, H.-S. Lee, K.-H. Park, S.J. Park
    PAL, Pohang, Kyungbuk, Republic of Korea
 
  The PAL-XFEL is a 0.1-nm hard X-ray FEL construction project which started from 2011 with a total budget of 400 M$. The PAL-XFEL is designed to have three hard X-ray undulator lines at the end of 10-GeV linac and a dog-leg branch line at 3 GeV point for two soft X-ray undulator lines. The three-bunch compressor lattice (3-BC) is chosen to have large flexibility of operation, making it possible to operate soft X-ray FEL undulator line simultaneously and independently from hard X-ray FEL line. Self seeding to achieve the FEL radiation bandwidth of below 5x10-5 is baseline for the hard X-ray FEL line. Polarization control will be available by using the PU + EPU layout for the soft X-ray FEL line. The overview of the project with current status is presented.  
slides icon Slides WEODB103 [8.332 MB]  
 
WEPWA043 Construction of Injector Test Facility (ITF) for the PAL XFEL 2220
 
  • S.J. Park, H. J. Choi, T. Ha, J.H. Han, J.H. Hong, W.H. Hwang, H.-S. Kang, T.-H. Kang, D.T. Kim, J.M. Kim, S.-C. Kim, I.S. Ko, B.H. Lee, H.-S. Lee, W.W. Lee, C.-K. Min, Y.J. Park, Y.G. Son
    PAL, Pohang, Kyungbuk, Republic of Korea
  • M.S. Chae
    POSTECH, Pohang, Kyungbuk, Republic of Korea
 
  Funding: Work supported by the Ministry of Education, Science and Technology (MEST) in Korea.
An injector test facility (ITF) for the PAL-XFEL has been successfully constructed and its commissioning is under way. The facility is to demonstrate beam performances required by the PAL XFEL (beam energy of 139 MeV, projected rms emittance of < 0.5 mm mrad @ 200 pC, and beam repetition rate of 60 Hz) with good enough stabilities. We have constructed a dedicated building for the facility in which a radiation-shielding tunnel (19.2-m long, 3.5-m wide, and 2.4-m high inner space), a klystron-modulator gallery, a laser room, and a control room are installed. The injector consists of an in-house-developed photo-cathode rf gun, a 30-mJ Ti:Sa laser system, two accelerating structures (as well as two sets of klystron-modulator systems), and various diagnostics as well as magnets & instrumentations. The installation of a transverse deflecting cavity (S-band, 10-fs resolution) and a laser heater is scheduled in 2013. In this article we report on the facility construction and some of the early commisisoning results.