Author: Blanco, J.
Paper Title Page
MOODB103 Results of an Experiment on Hydrodynamic Tunnelling at the SPS HiRadMat High Intensity Proton Facility 37
 
  • R. Schmidt, J. Blanco, F. Burkart, D. Grenier, D. Wollmann
    CERN, Geneva, Switzerland
  • E. Griesmayer
    CIVIDEC Instrumentation, Wien, Austria
  • N.A. Tahir
    GSI, Darmstadt, Germany
 
  To predict the damage for a catastrophic failure of the protections systems for the LHC when operating with beams storing 362 MJ, simulation studies of the impact of an LHC beam on targets were performed. Firstly, the energy deposition of the first bunches in a target with FLUKA is calculated. The effect of the energy deposition on the target is then calculated with a hydrodynamic code, BIG2. The impact of only a few bunches leads to a change of target density. The calculations are done iteratively in several steps and show that such beam can tunnel up to 30-35 m into a target. Validation experiments for these calculations at LHC are not possible, therefore experiments were suggested for the CERN Super Proton Synchrotron (SPS), since simulation studies with the tools used for the LHC also predict hydrodynamic tunnelling for SPS beams. An experiment at the SPS-HiRadMat facility (High-Radiation to Materials) using the 440 GeV beam with 144 bunches was performed in July 2012. In this paper we compare the results of this experiment with our calculations of hydrodynamic tunnelling.  
slides icon Slides MOODB103 [40.426 MB]  
 
THPEA047 Diamond Particle Detector Properties during High Fluence Material Damage Tests and their Future Applications for Machine Protection in the LHC 3249
 
  • F. Burkart, J. Blanco, J. Borburgh, B. Dehning, M. Di Castro, E. Griesmayer, A. Lechner, J. Lendaro, F. Loprete, R. Losito, S. Montesano, R. Schmidt, D. Wollmann, M. Zerlauth
    CERN, Geneva, Switzerland
  • E. Griesmayer
    CIVIDEC Instrumentation, Wien, Austria
 
  Experience with LHC machine protection (MP) during the last three years of operation shows that the MP systems sufficiently protect the LHC against damage in case of failures leading to beam losses with a time constant exceeding 1ms. An unexpected fast beam loss mechanism, called UFOs, was observed, which could potentially quench superconducting magnets. For such fast losses, but also for better understanding of slower losses, an improved understanding of the loss distribution within a bunch train is required. Diamond particle detectors with bunch-by-bunch resolution and high dynamic range have been developed and successfully tested in the LHC and in experiments to quantify the damage limits of LHC components. This paper will focus on experience gained in use of diamond detectors. The properties of these detectors were measured during high-fluence material damage tests in CERN's HiRadMat facility. The results will be discussed and compared to the cross-calibration with FLUKA simulations. Future applications of these detectors in the LHC to understand beam losses and to improve the protection against fast particle losses will be discussed.