Author: Uchiyama, T.
Paper Title Page
MOPPP035 Initial Emittance and Temporal Response Measurement for GaAs Based Photocathodes 640
 
  • S. Matsuba
    Hiroshima University, Graduate School of Science, Higashi-Hiroshima, Japan
  • Y. Honda, T. Miyajima, T. Uchiyama, M. Yamamoto
    KEK, Ibaraki, Japan
  • X.G. Jin
    Institute for Advanced Research, Nagoya, Japan
  • Y. Takeda
    Nagoya University, Nagoya, Japan
 
  For future light source based on Energy Recovery Linac (ERL) is planned in KEK. For the ERL, an ultra low emittance and fast temporal response and high current electron source is needed. To achieve these requirements, a high voltage DC gun with a Negative Electron Affinity photo-cathode is under development. In this development, it is important to investigate the performance of photo-cathodes. We have constructed an ERL gun test stand to measure emittance and temporal profile. We use a solenoid scan technique for emittance measurements and a deflecting cavity technique for temporal profile measurements. In this presentation, we introduce KEK ERL gun test stand and beam test results.  
 
TUPPP016 Recent Development of PF Ring and PF-AR 1641
 
  • Y. Tanimoto, T. Aoto, S. Asaoka, K. Endo, K. Haga, K. Harada, T. Honda, Y. Honda, M. Izawa, Y. Kobayashi, A. Mishina, T. Miyajima, H. Miyauchi, S. Nagahashi, N. Nakamura, T. Nogami, T. Obina, T. Ozaki, C.O. Pak, H. Sakai, S. Sakanaka, H. Sasaki, Y. Sato, K. Satoh, M. Shimada, K. Shinoe, T. Shioya, M. Tadano, T. Tahara, T. Takahashi, R. Takai, K. Tsuchiya, T. Uchiyama, A. Ueda, K. Umemori, M. Yamamoto
    KEK, Ibaraki, Japan
  • H. Takaki
    ISSP/SRL, Chiba, Japan
 
  After the earthquake of March 11, two light sources of KEK, PF ring and PF-AR, have recovered the regular operation from October, 2011. We installed tandem variably-polarized undulators at PF ring in 2009. Recently, the orbit switching system has been completed with sufficient feed-forward orbit compensation at 10-Hz. PF ring is usually operated at 450 mA with a top-up injection using the pulsed sextupole magnet instead of the conventional kicker magnets. The transverse and longitudinal instabilities are suppressed by a digital feedback system using the iGp signal processor. In the longitudinal direction, we observed unstable quadrupole mode oscillation which could not be controlled by the feedback system. We had applied the phase modulation of the main RF cavity to stabilize the quadrupole oscillation before. Old-type RF-shielded gate valves damaged by the earthquake were removed from the ring during the summer maintenance. In the operation after autumn, the quadrupole oscillation can be cured by dividing the bunch train of partial-filling. Without the phase modulation, the effective brightness of SR beam has been improved especially at beam lines of finite dispersion function.