Author: Santana, M.
Paper Title Page
MOPPD047 Progress of Surface Plasma H Ion Source with Saddle RF Antenna Plasma Generator 469
  • V.G. Dudnikov, R.P. Johnson
    Muons, Inc, Batavia, USA
  • S.N. Murray, T.R. Pennisi, C. Piller, M. Santana, M.P. Stockli, R.F. Welton
    ORNL, Oak Ridge, Tennessee, USA
  Funding: Supported in part by SBIR Grant 4729 · 09SC02690.
Progress in development of RF H surface plasma source (SPS) with saddle (SA) RF antenna which will provide better power efficiency for high pulsed and average current, higher brightness with longer lifetime and higher reliability will be considered. Several versions of new plasma generators with a small Al2O3chamber and different antennas and magnetic field configurations were tested in the SNS small Test Stand. A prototype SA SPS was installed in the Test Stand with a larger, normal-sized SNS AlN chamber that achieved unanalyzed peak currents of up to 67 mA with an apparent efficiency of 1.6 mA/kW. Control experiments with H beam produced by SNS SPS with internal and external antennas in the similar conditions were conducted. A new version of the RF triggering plasma source (TPS) has been designed and fabricated. A Saddle antenna SPS with water cooling is being fabricated for high duty factor testing
TUPPD048 Optical Emission Spectroscopy Studies of the Spallation Netron Source (SNS) H Ion Source 1512
  • B. Han, S.N. Murray
    ORNL RAD, Oak Ridge, Tennessee, USA
  • T.R. Pennisi, M. Santana, M.P. Stockli, R.F. Welton
    ORNL, Oak Ridge, Tennessee, USA
  A Cs enhanced, RF-driven H ion source feeds the SNS accelerator with a 65 keV H beam at 60 Hz with a pulse length of up to 1.0 ms. The ion source beam intensity and reliability are critical to the SNS operational power level and availability. The 1-MW level routine operation of the SNS requires ~38 mA beam in the linac. This requirement is normally met by the ion source in a persistent manner for a 4-5 weeks service-cycle of the ion source. But, in some occasions, the ion source either falls short of the beam current or fails to keep the beam current persistent. The key factor in achieving high current, persistent H beam is to have a proper coverage of Cs on the ion converter surface near the source outlet. To quantify the amount of Cs put into the system during cesiation(s) and to monitor the Cs migration during the source operation, an experimental study is under way with an optical spectrometer monitoring the emission lights from the ion source plasma. Another possible use of this emission spectroscopy study is to detect the indication of the ion source antenna deterioration before it develops into a total failure. The progress and some preliminary results are presented.