IPAC2012 - List of Authors (Jiao, Y.)

Paper	Title	Page
MOPPC020	Field Tolerances for the Triplet Quadrupoles of the LHC High Luminosity Lattice	169
	Y. Jiao, Y. Cai, Y. Nosochkov, M.-H. Wang SLAC, Menlo Park, California, USA R. De Maria, S.D. Fartoukh, M. Giovannozzi, E. McIntosh CERN, Geneva, Switzerland
	Funding: This work is supported by the U.S. Department of Energy under contract # DE-AC02-76SF00515 and the US LHC Accelerator Research Program (LARP). It has been proposed to implement an Achromatic Telescopic Squeezing (ATS) scheme* in the high luminosity LHC lattice to reduce the beta functions at the Interaction Points (IP) up to a factor of 8. As a consequence, the nominal 4.5-km peak beta functions reached in the inner triplets at collision will be increased by the same factor. This therefore justifies the installation of new, larger aperture superconducting triplet quadrupoles. These higher beta functions will enhance the effects of the triplet quadrupole field errors leading to smaller beam dynamic aperture. To maintain the acceptable dynamic aperture, the effects of the triplet multipole field errors must be re-evaluated, thus specifying new tolerances. Such a study has been performed for the so-called “4444” collision optics of the ATS scheme, where the IP beta functions are reduced by a factor of 4 in both planes with respect to a pre-squeezed value of 60 cm at two collision points. The dynamic aperture calculations were performed using SixTrack. The impact on the triplets’ field quality is studied and presented in details. * S. Fartoukh, “An Achromatic Telescopic Squeezing (ATS) Scheme for LHC Upgrade”, Proc. of IPAC11, p. 2088 (2011).

TUPPP082	Optimization of a Terawatt Free Electron Laser	1780
	J. Wu, X. Huang, Y. Jiao, A.U. Mandlekar, T.O. Raubenheimer, S. Spampinati, G. Yu SLAC, Menlo Park, California, USA P. Chu FRIB, East Lansing, Michigan, USA J. Qiang LBNL, Berkeley, California, USA
	Funding: Work supported by U.S. Department of Energy, Office of Basic Energy Sciences, under Contract DE-AC02-76SF00515. There is great interest in generating a terawatt (TW) hard X-ray free electron laser (FEL) that will enable coherent diffraction imaging of complex molecules like proteins and probe fundamental high-field physics. A feasibility study of producing such pulses was carried out em- ploying a configuration beginning with an SASE amplifier, followed by a "self-seeding" crystal monochromator, and finishing with a long tapered undulator. The undulator tapering profile, the phase advance in the undulator break sections, the quadrupole focusing strength, etc. are parameters to be optimized. A genetic algorithm (GA) is adopted for this multi-dimensional optimization. Concrete examples are given for LCLS/LCLS-II systems.

TUPPP083	Multi-Dimensional Optimization of a Tapered Free Electron Laser	1783
	Y. Jiao, J. Wu SLAC, Menlo Park, California, USA Q. Qin IHEP, Beijing, People's Republic of China
	Energy extraction efficiency of a free electron laser (FEL) can be increased when the undulator is tapered. In this paper, we report a multi-dimensional optimizer to maximize the radiation power in a tapered FEL by searching for an optimal taper profile as well as a reasonable variation in electron beam radius. Applications of the proposed multi-dimensional optimization to the terawatt-level, tapered FELs with LCLS-like electron beam parameters are presented, and the proposed optimization scheme is compared with the GINGER’s self-design taper algorithm. At the end, the dependence of the available maximum radiation power on various parameters of the initial electron beam, the initial radiation field and the undulator system is summarized.

TUPPP084	Efficiency Enhancement in a Tapered Free Electron Laser by Varying the Electron Beam Radius	1786
	Y. Jiao, J. Wu SLAC, Menlo Park, California, USA Q. Qin IHEP, Beijing, People's Republic of China
	Energy extraction efficiency of a free electron laser (FEL) can be increased when the undulator is tapered. An in-depth understanding of the tapering-related physics is required to explore the full potential of a tapered FEL, not only by tapering the undulator parameters in longitudinal dimension, but also optimizing the transverse effects. Based on the modified 1D FEL model and time-steady numerical simulations, we study the contribution of the variation in electron beam radius and the related transverse effects. Taking a terawatt-level, 120-m tapered FEL as example, we demonstrate that a reasonably varied, instead of a constant, electron beam radius along the undulator helps to improve the optical guiding and thus the radiation output.

Paper

Title

Page

Field Tolerances for the Triplet Quadrupoles of the LHC High Luminosity Lattice

169

Y. Jiao, Y. Cai, Y. Nosochkov, M.-H. Wang
SLAC, Menlo Park, California, USA
R. De Maria, S.D. Fartoukh, M. Giovannozzi, E. McIntosh
CERN, Geneva, Switzerland

Funding: This work is supported by the U.S. Department of Energy under contract # DE-AC02-76SF00515 and the US LHC Accelerator Research Program (LARP).
It has been proposed to implement an Achromatic Telescopic Squeezing (ATS) scheme* in the high luminosity LHC lattice to reduce the beta functions at the Interaction Points (IP) up to a factor of 8. As a consequence, the nominal 4.5-km peak beta functions reached in the inner triplets at collision will be increased by the same factor. This therefore justifies the installation of new, larger aperture superconducting triplet quadrupoles. These higher beta functions will enhance the effects of the triplet quadrupole field errors leading to smaller beam dynamic aperture. To maintain the acceptable dynamic aperture, the effects of the triplet multipole field errors must be re-evaluated, thus specifying new tolerances. Such a study has been performed for the so-called “4444” collision optics of the ATS scheme, where the IP beta functions are reduced by a factor of 4 in both planes with respect to a pre-squeezed value of 60 cm at two collision points. The dynamic aperture calculations were performed using SixTrack. The impact on the triplets’ field quality is studied and presented in details.
* S. Fartoukh, “An Achromatic Telescopic Squeezing (ATS) Scheme for LHC Upgrade”, Proc. of IPAC11, p. 2088 (2011).

TUPPP082

Optimization of a Terawatt Free Electron Laser

1780

J. Wu, X. Huang, Y. Jiao, A.U. Mandlekar, T.O. Raubenheimer, S. Spampinati, G. Yu
SLAC, Menlo Park, California, USA
P. Chu
FRIB, East Lansing, Michigan, USA
J. Qiang
LBNL, Berkeley, California, USA

Funding: Work supported by U.S. Department of Energy, Office of Basic Energy Sciences, under Contract DE-AC02-76SF00515.
There is great interest in generating a terawatt (TW) hard X-ray free electron laser (FEL) that will enable coherent diffraction imaging of complex molecules like proteins and probe fundamental high-field physics. A feasibility study of producing such pulses was carried out em- ploying a configuration beginning with an SASE amplifier, followed by a "self-seeding" crystal monochromator, and finishing with a long tapered undulator. The undulator tapering profile, the phase advance in the undulator break sections, the quadrupole focusing strength, etc. are parameters to be optimized. A genetic algorithm (GA) is adopted for this multi-dimensional optimization. Concrete examples are given for LCLS/LCLS-II systems.

TUPPP083

Multi-Dimensional Optimization of a Tapered Free Electron Laser

1783

Y. Jiao, J. Wu
SLAC, Menlo Park, California, USA
Q. Qin
IHEP, Beijing, People's Republic of China

Energy extraction efficiency of a free electron laser (FEL) can be increased when the undulator is tapered. In this paper, we report a multi-dimensional optimizer to maximize the radiation power in a tapered FEL by searching for an optimal taper profile as well as a reasonable variation in electron beam radius. Applications of the proposed multi-dimensional optimization to the terawatt-level, tapered FELs with LCLS-like electron beam parameters are presented, and the proposed optimization scheme is compared with the GINGER’s self-design taper algorithm. At the end, the dependence of the available maximum radiation power on various parameters of the initial electron beam, the initial radiation field and the undulator system is summarized.

TUPPP084

Efficiency Enhancement in a Tapered Free Electron Laser by Varying the Electron Beam Radius

1786

Y. Jiao, J. Wu
SLAC, Menlo Park, California, USA
Q. Qin
IHEP, Beijing, People's Republic of China

Energy extraction efficiency of a free electron laser (FEL) can be increased when the undulator is tapered. An in-depth understanding of the tapering-related physics is required to explore the full potential of a tapered FEL, not only by tapering the undulator parameters in longitudinal dimension, but also optimizing the transverse effects. Based on the modified 1D FEL model and time-steady numerical simulations, we study the contribution of the variation in electron beam radius and the related transverse effects. Taking a terawatt-level, 120-m tapered FEL as example, we demonstrate that a reasonably varied, instead of a constant, electron beam radius along the undulator helps to improve the optical guiding and thus the radiation output.