• B. Bolzon, L. Brunetti, A. Jeremie
  IN2P3-LAPP, Annecy-le-Vieux
• M. Esposito, U. Rotundo, S. Tomassini
  INFN/LNF, Frascati (Roma)

Following previous measurements, more detailed preliminary ground motion measurements have been performed at the LNF site for the Super B project site characterization. First, results of vertical ground motion measurements done during 18 hours are shown in order to get an idea of the evolution of the ground motion amplitude with time. Secondly, measurements of ground motion (in the 3 directions of space) were performed at different locations on surface in order to evaluate and to compare the influence of various vibration sources. Then, results of ground motion coherence measured for different distances at two locations close to each other but with soft and rigid floor are compared. These measurements are also compared to the ones done in the ATF2 beam line where a special floor was built for stability. By this way, the results reveal that the LNF is a good site to use ground motion coherence properties for stability like it has been done for ATF2.

• J. Pfingstner, D. Schulte
  CERN, Geneva
• M. Hofbaur
  UMIT, Hall in Tirol

One of the major challenges of the CLIC main linac is the preservation of the ultra-low beam emittance. The dynamic effect of ground motion would lead to a rapid emittance increase. Orbit feedback systems (FB) have to be optimized to efficiently attenuate ground motion (disturbance), in spite of drifts of accelerator parameters (imperfect system knowledge). This paper presents a new FB strategy for the main linac of CLIC. It addresses the above mentioned issues, with the help of an adaptive control scheme. The first part of this system is a system identification unit. It delivers an estimate of the time-varying system behavior. The second part is a control algorithm, which uses the most recent system estimate of the identification unit. It uses H2 control theory to deliver an optimal prediction of the ground motion. This approach takes into account the frequency and spacial properties of the ground motion, as well as their impact on the emittance growth.

• K. Artoos, C.G.R.L. Collette, P. Fernandez Carmona, M. Guinchard, C. Hauviller, S.M. Janssens, A.M. Kuzmin, A. Slaathaug, M.V. Sylte
  CERN, Geneva

A prerequisite for a successful nanometre level magnet stabilization and pointing system is a low background vibration level. This paper will summarize and compare the ground motion measurements made recently in different accelerator environments at e.g. CERN, CESRTA and PSI. Furthermore the paper will give the beginning of an inventory and characterization of some technical noise sources, and their propagation and influence in an accelerator environment. The importance of the magnet support is also mentioned. Finally, some advances in the characterization of the nanometre vibration measurement techniques will be given.

• R. Tomás, B. Dalena, J. Pfingstner, D. Schulte, J. Snuverink
  CERN, Geneva
• J.K. Jones
  Cockcroft Institute, Warrington, Cheshire
• A. Latina
  Fermilab, Batavia
• J. Resta-López
  JAI, Oxford

The CLIC BDS tuning, alignment and feedbacks studies have been typically performed independently and only over particular sections of the BDS. An effort is being put to integrate all these procedures to realistically evaluate the luminosity performance.