Author: Maesaka, H.
Paper Title Page
TUPSO46 Analysis and Measurement of Focusing Effects in a Traveling Wave Linear Accelerator 329
 
  • H. Maesaka, T. Asaka, H. Ego, T. Hara, T. Inagaki, Y. Otake, T. Sakurai, H. Tanaka, K. Togawa
    RIKEN SPring-8 Center, Sayo-cho, Sayo-gun, Hyogo, Japan
 
  We propose a further precise model of the transverse dynamics in a traveling wave linear accelerator (TWA) and report experimental results to demonstrate the validity of the model. In SACLA, the beam orbit is calculated by using a transfer matrix based on the transverse dynamics model of each component and the matrix is utilized for orbit stabilization, beam envelop matching etc. For the TWA part, a transfer matrix including an emittance damping effect and an edge focusing effect [*] is employed. However, the beam orbit measured by rf cavity beam position monitors (RF-BPM) [**] did not agree with the calculated orbit, especially for the off-crest acceleration part. Therefore, focusing effects in a TWA structure were analyzed by using a 3-dimensional rf simulation code. The analysis indicated that the transverse dynamics model of the TWA should include an additional quadrupole edge focusing effect. The amount of the additional focusing effect of the TWA was measured in SACLA and the rf simulation result was confirmed to be consistent with the measurement. After the modification of the transverse dynamics model, the beam orbit measured by RF-BPM agrees with the calculation.
* T. Hara et al., Nucl. Instrum. Methods A 624, 65 (2010).
** H. Maesaka et al., Nucl. Instrum. Methods A 696, 66 (2012).