Author: Tanaka, Y.
Paper Title Page
THPA17 Study of the Back-bombardment Effect in the ITC-Rf Gun for t-ACTS Project at Tohoku University 503
 
  • X. Li, H. Hama, F. Hinode, S. Kashiwagi, M. Kawai, T. Muto, K. Nanbu, Y. Tanaka
    Tohoku University, Research Center for Electron Photon Science, Sendai, Japan
  • F. Miyahara
    KEK, Ibaraki, Japan
 
  A specially designed thermionic RF gun which consists of two independently tunable cells [1] (ITC) is used to produce sub-picoseconds electron pulses as the source for coherent terahertz radiation at Tohoku University. Simulations of particle motion show that the back-bombardment effect on the LaB6 cathode surface is serious and should be controlled carefully. Using EGS5 [2] the power deposition of the back-bombardment inside the cathode can be calculated by using the information of back-streaming electrons derived from GPT [3] simulation, and further used to evaluate the temperature increase on the cathode surface by numerically solving a 2-dimentional equation for heat conduction. In the 2D model, the back-streaming electrons are treated as external heat source as well as the cathode heater that heats the cathode from its side along with thermal radiation from its surface. In addition, some methods will be proposed to reduce the back-bombardment effect and we will also compare the simulation results with experimental data.
[1] H. Hama et al., New J. Phys. 8 (2006) 292
[2] Electron Gamma Shower, http://rcwww.kek.jp/research/egs/egs5.html
[3] General Particle Tracer, http://www.pulsar.nl/gpt
 
 
THPA31 Commissioning of ITC-RF Gun for t-ACTS Project at Tohoku University 547
 
  • F. Hinode, H. Hama, S. Kashiwagi, M. Kawai, X. Li, T. Muto, K. Nanbu, Y. Tanaka
    Tohoku University, Research Center for Electron Photon Science, Sendai, Japan
  • F. Miyahara
    KEK, Ibaraki, Japan
 
  Funding: This work is partially supported by the Ministry of Education, Science, Sports and Culture, Grant-in-Aid for Scientific Research (S), Contract #20226003.
A test accelerator as the coherent terahertz source project (t-ACTS) is in progress at Tohoku University, in which an isochronous ring and a bunched free electron laser will provide the intense terahertz radiation by dint of the sub-picoseconds electron pulses [1, 2]. A thermionic RF gun with two independently-tunable cells (ITC), an alpha magnet and a 3 m accelerating structure are employed in the t-ACTS injector for the short pulse generation. Tracking simulations show that very short electron pulse less than 100 fs with a bunch charge of about 20 pC can be obtained by means of the velocity bunching scheme [2]. Although the usable amount of the extracted beam from the ITC-RF gun is quite small comparing with photo-injectors, there seem to be distinct features such as the better stability and the multi-bunch capability. High power RF processing for the gun has already been accomplished, and then the beam commissioning will be started soon. We will report results of beam commissioning of the ITC-RF gun and also present the current status of t-ACTS project.
[1] H. Hama et al., New J. Phys. 8 (2006) 292,
[2] H. Hama and M. Yasuda, Proc. of FEL2009, TUPC69, (2009) 394
[3] F. Miyahara et al., Proc. of IPAC'10, THPD094, (2010) 4509
 
 
THPB08 Study of Reflective Optics for LFC-Camera 576
 
  • K. Nanbu
    Tohoku University, School of Science, Sendai, Japan
  • H. Hama, F. Hinode, S. Kashiwagi, M. Kawai, X. Li, T. Muto, Y. Tanaka
    Tohoku University, Research Center for Electron Photon Science, Sendai, Japan
 
  Funding: This work is partially supported by the Ministry of Education, Science, Sports and Culture, Grant-in-Aid for Scientific Research (S), Contract #20226003.
A test accelerator for the terahertz source project (t-ACTS) employing isochronous ring and bunched free electron laser has been under development at Tohoku University [1,2]. Stable production of very short electron bunches is a key issue for the t-ACTS project. We have chosen thermionic RF gun for the injector of t-ACTS because of stability, multi-bunch operation and cheaper cost. The longitudinal phase space distribution of the beam extracted from the rf-gun is crucial for the final bunch length of electron beam passing through bunch compression process. Therefore, measurement of the longitudinal phase space of the beam is indispensable for efficient bunch compression. In order to measure the electron distribution in the longitudinal phase space of relatively lower energy beam, we have been developing a novel method to observe the energy spectrum employing a velocity dependence of opening angle of Cherenkov radiation, namely Linear Focal Cherenkov (LFC) ring camera. We describe principle of LFC camera and discuss relations between surface roughness of Cherenkov radiator and energy resolution in this conference.
[1] H. Hama et al., New J. Phys. 8 (2006) 292,
[2] H. Hama and M. Yasuda, Proc. of FEL2009, (2009) 394
 
 
WEPB16 Study for Evaluation of Undulator Magnetic Field Using Vibrating Wire Method 413
 
  • Y. Tanaka
    Tohoku University, School of Science, Sendai, Japan
  • H. Hama, F. Hinode, S. Kashiwagi, M. Kawai, X. Li, T. Muto, K. Nanbu
    Tohoku University, Research Center for Electron Photon Science, Sendai, Japan
 
  A test accelerator for a terahertz source project (t-ACTS) has been progressed at the Electron Light Science Centre, Tohoku University, in which a generation of intense coherent terahertz radiation from the very short electron bunch will be demonstrated. A narrow-band coherent terahertz radiation using an undulator has been considered to be implemented. We have constructed a planer undulator that is basically a Halbach type composed of permanent magnet blocks. The period length of the undulator and the number of periods are 100 mm and 25, respectively. The vibrating wire method is studied to measure the periodic magnetic field of the undulator. A thin copper-beryllium wire is placed on beam axis in the undulator, and an AC current flow is applied in the wire. By measuring amplitudes and phases of standing waves excited on the wire by the Lorentz force between AC current and magnetic field, we can reconstruct the magnetic field distribution along the wire. We discuss relations between reproducibility of the undulator field and the mode harmonics number used for the reconstruction. The results of preliminary measurement using the vibrating wire will be shown in this conference.