SLAC, Menlo Park, California, USA
SLAC, Menlo Park, California, USA
To further enhance the LCLS injector performances or simplify its operating conditions, we are evaluating the various parameters including the photocathode drive laser. Simulations show that both the projected and time-sliced emittances with spatial Gaussian profiles having reasonable tail-cutoff are better than those with uniform one. The simulated results are also supported by theoretical analyses. In the LCLS, the spatial uniform or quasi-Gaussian laser profiles are conveniently obtained by adjusting the optics of telescope upstream of an iris, used to define laser size on the cathode. Preliminary beam studies at the LCLS show that both the projected and time-sliced emittances with spatial quasi-Gaussian laser are almost as good as, although not better than, those with uniform one, and also laser transmission through the iris with the quasi-Gaussian is twice that with uniform one, which is to ease copper cathode operations and thus improve the LCLS operation efficiency. More beam studies are planned in the coming summer to measure FEL performances with the quasi-Gaussian in comparison with the uniform one. All simulations and measurements are presented.
DESY, Hamburg, Germany
SLAC, Menlo Park, California, USA
SLAC, Menlo Park, California, USA
Control and knowledge of the spectrum of FEL X-ray radiation at the LCLS is important to the quality and interpretation of experimental results. Narrow bandwidth is useful in experiments requiring high-brightness beams. Wide bandwidth is particularly useful for photon energy calibration using absorption spectra. Since LCLS was commissioned in 2009 measurements have been made of average and single shot spectra of X-ray FEL radiation at the LCLS over a range of 800 to 8000 eV, for fundamental and harmonic radiation. These include correlations with chirp, bunch current, undulator K-taper, electron beam energy, and charge as well as some specialized machine configurations. In this paper we present results and discuss the relationship of the electron beam energy distribution to the observed X-ray spectrum.
SLAC, Menlo Park, California, USA
Understanding and controlling the transverse size and distribution of FEL X-ray radiation of the LCLS at the SLAC National Accelerator Laboratory is discussed. Understanding divergence, source size, and distributions under various conditions is a convolution of many effects such as the electron distribution, the undulator alignment, micro-bunching suppression, and beta-match. Measurements of transverse size along the X-ray pulse and other studies designed to sort out the dominant effects are presented and discussed.
SLAC, Menlo Park, California, USA
The FEL of the Linac Coherent Light Source (LCLS) at SLAC is generated in a 132 m long undulator. By introducing a kink in the undulator setup and launching different electron pulses with a small kick, we achieved two FEL beams with a separation of about 10 σ. These beams were separated at down stream mirrors and brought to the entrances of the soft and hard X-ray hutches. This was done at low energy creating soft X-rays which require only a shorter length to get to saturation. At high energy the whole undulator has to be "re-pointed" pulse by pulse. This can be done using 33 undulator correctors creating two straight lines for the photons with small angle to point the FEL to different mirrors pulse by pulse even at high energy. Experiments will be presented and further ideas discussed to get different energy photons created and sent to the soft and hard X-ray mirrors and experiments.