DESY Zeuthen, Zeuthen
DESY, Hamburg
YerPhI, Yerevan
Chiang Mai University, Chiang Mai
A new photocathode electron gun is about to be characterized at PITZ*. It is an L-band normal conducting 1.6 copper cell cavity with improved cooling system. It has the same design as the previously installed gun, characterized at PITZ during the run period 2008/9**. Due to the particle-free surface cleaning method utilizing dry ice, a significant reduction of the dark current was achieved in case of the previously tested cavity. This effect is also expected for the new gun. To improve the accuracy of the RF power measurement and control, a new in-vacuum directional coupler was installed between the T-combiner combining the two 5 MW arms of the RF source and the input coaxial coupler. The new in-vacuum coupler will provide much more accurate information about the RF power in the gun and will allow applying appropriate control feedback. Consequently improved stability of the gun operation is expected. Tuning and conditioning results of this new gun cavity will be presented as well as the results of the measurements of the gradient and the gun phase measurements using this new coupler.
* Photoinjector Test Facility at Zeuthen
** S. Rimjaem et al., EPAC 2008, Genoa, Italy.
DESY Zeuthen, Zeuthen
MBI, Berlin
DESY, Hamburg
UCLA, Los Angeles, California
HZB, Berlin
Uni HH, Hamburg
The Photo Injector Test facility at DESY, Zeuthen site (PITZ), develops and optimizes electron sources for Free Electron Lasers (FEL’s) such as FLASH and European XFEL. The electrons are generated by the photo effect using a cesium telluride (Cs2Te) cathode and are accelerated in an 1.6-cell L-band RF-gun cavity with about 60MV/m maximum accelerating field at the cathode. The upgraded laser system at PITZ produces flat-top and Gaussian laser pulses of different time durations. Emittance measurements have been done for short Gaussian laser temporal profile ~2ps FWHM and for 6.6 MeV electron beam energy. The transverse projected emittance was measured for various transverse laser spot sizes at the cathode and different low bunch charges to find an optimum condition for thermal emittance measurements. ASTRA simulations were performed for various measurement conditions to estimate the space charge contribution to the emittance. The comparison of emittance measurement results and simulations is presented and discussed in this contribution.
DESY Zeuthen, Zeuthen
DESY, Hamburg
UCLA, Los Angeles, California
HZB, Berlin
The major objectives of the Photo-Injector Test Facility at DESY in Zeuthen, PITZ, are research and development of high brightness electron sources suitable to drive FELs like FLASH and the European XFEL. In the 2008/2009 run period the facility has been operated with a new photo-cathode laser system and a dry-ice cleaned RF gun cavity. Characterization of the transverse phase space of the electron source has been performed in details using a single slit scan technique with a dedicated Emittance Measurement System. In preparation for the forthcoming run, a number of quadrupole magnets have been installed and tomography reconstruction with data from quadrupole scans with two magnets has been carried out in semi-parallel manner to the slit scans. This contribution summarizes the experience from the phase-space tomography reconstruction with nominal beam conditions. Advantages and drawbacks of the measurement procedure and the analysis are superimposed and results are compared to ones obtained with the slit scans.
