JASRI/SPring-8, Hyogo-ken
JAEA/Kansai, Kyoto
SOLEIL, Gif-sur-Yvette
RIKEN/SPring-8, Hyogo
The University of Tokyo, Tokyo
Keio University, Kanagawa-ken
RIKEN, Saitama
NTT Corp., Kanagawa-ken
KEK, Tsukuba
A seeded FEL is the most promised way to generate fully coherent radiation in a short-wavelength region. After the improvement of the laser and HHG system at the SCSS test accelerator, we have succeeded the amplification of the seed, for the first time, in the plateau region. The wavelength of the seed is 61.5 nm, which is the 13th harmonic of a Ti:Sa laser, and clear intensity increase and spectral narrowing by the FEL was observed. Although there still remains room for optimization of the transverse matching and synchronization of the seed, this result leads to realization of a fully coherent light source to users in VUV and soft x-ray regions.
RIKEN/SPring-8, Hyogo
JASRI/SPring-8, Hyogo-ken
To measure the femtosecond bunch length (10 - {10}00 fs) of the XFEL facility at SPring-8, we developed a coherent synchrotron radiation (CSR) monitor and a streak camera system. A pyro-electric detector was employed to measure the CSR intensity, since the CSR frequency region is THz or far infra-red. The CSR source is a dipole magnet of a chicane section. For the streak camera, we used Hamamatsu FESCA200, which has 200 fs resolution. The temporal structure of the optical transition radiation (OTR) from a metal mirror is observed by this camera. By using these monitors, the bunch length dependence was measured as a function of the rf phase of an S-band accelerator upstream of the bunch compressor at the SCSS test accelerator. A strong correlation between the CSR intensity and the S-band phase was observed. The CSR intensity was small at a debunching phase and the intensity increased as the rf phase was shifted to the bunching direction. Finally, it decreased in the over-bunching region. The bunch length data from the streak camera also had the same tendency. Thus, the bunch compression characteristics were appropriately measured and were consistent with our simulation results.
JASRI/SPring-8, Hyogo-ken
RIKEN/SPring-8, Hyogo
University of Tokyo, Tokyo
UTNL, Ibaraki
We developed a single-shot and non-destructive 3D bunch charge distribution (BCD) monitor based on Electro-Optical (EO) sampling with a manner of spectral decoding for XFEL/SPring-8. For the transverse detection, eight EO-crystals (Pockels effect) surround the beam axis azimuthally, and a linear-chirped probe laser pulse with a hollow shape passes through the EO-crystal. We plan to use an amorphous material which has only an even-order field dependence (Kerr effect) in donut shape without assembling eight conventional EO-crystals. The polarization axis of the probe laser should be radially distributed as well as the Coulomb field of the electron bunches. Since the signal intensity encoded at each crystal depends on the strength of the Coulomb field at each point, we can detect the transverse BCD. In the longitudinal detection, we use a prove laser with a broadband square spectrum (> 400 nm @ 800 nm) so that the temporal resolution is < 30 fs, if the pulse width of probe laser is 500 fs. In order to achieve 30-fs temporal resolution, we use an organic EO material, DAST crystal, which is transparent up to 30 THz. We report the first experimental results of our 3D-BCD monitor.
RIKEN/SPring-8, Hyogo
JASRI/SPring-8, Hyogo-ken
A pump-probe experiment at XFEL/SPring-8 is one of the most prominent parts to extract the future of a coherent short-pulse X-ray laser. A commercial Ti:Sapphire mode-locked laser is presently used as a pump laser, while a probe laser is the XFEL. However, the time jitter of the commercial mode locked laser, as which is caused by the noise of an electrical mode-locking circuit, is around several hundred femto-seconds. This jitter value is not sufficient for a temporal resolution requirement of our pump-probe experiment with a laser pulse width of several ten femto-seconds. To improve this time jitter, the method, using a 770 nm Ti:Sapphire laser amplifiers directly triggered by a 1540 nm master optical oscillator as a time reference signal source for an XFEL accelerator, was devised. This method could eliminate the noise caused by the electrical mode-locking circuit. The basic principle of the method was proved by a preliminary experiment with laser pulse manipulation employing an E/O crystal shutter with a several ten ps response. This presentation describes a basic idea of this pump–probe method, a preliminary experiment set-up to check its feasibility, and experiment results.