Paper | Title | Page |
---|---|---|
MPPT025 | Field Quality and Magnetic Center Stability Achieved in a Variable Permanent Magnet Quadrupole for the ILC | 1913 |
|
||
Funding: Work supported in part by Department of Energy contract DEAC0376SF00515 and by the Ministry of Education, Science, Sports and Culture, Japan, Grant-in-Aid for Scientific Research (A) 14204023. The precise tolerances on the last two quadrupoles before the interaction point of the proposed, superconducting e+e- collider (ILC) have not been determined yet. These quads will be aligned with a beam-based alignment (BBA) process during which their integrated strengths will be decreased by 20%. Their magnetic centers must move by less than a few microns during the BBA else a systematic error will be introduced, yielding an increase in the beam spot size. These strong quads must be small to fit in the tight space. A compact, variable, superstrong permanent magnet quad (PMQ) has been fabricated and tested. The PMQ has inner and outer rings of NEOMAX; the outer ring is subdivided along its length and each section can rotate. By rotating different lengths one can vary the integrated strength in small steps. Because of the fixed inner ring and tight mechanical tolerances, the sensitivities of the magnetic center and pole angles to the rotation of the outer rings are largely suppressed. Measurements of the PMQ will be presented, plus how observed small center and angle shifts were further reduced by adjustments to the stopping angles of the rotating rings and by shimming these rings. |
||
MPPT029 | Performance of an Adjustable Strength Permanent Magnet Quadrupole | 2071 |
|
||
Funding: Department of Energy Grant DE-FG03-01ER83305. An adjustable strength permanent magnet quadrupole suitable for use in Next Linear Collider has been built and tested. The pole length is 42cm, aperture diameter 13mm, peak pole tip strength 1.03Tesla and peak integrated gradient * length (GL) is 68.7 Tesla. This paper describes measurements of strength, magnetic centerline and field quality made using an air bearing rotating coil system. The magnetic centerline stability during -20% strength adjustment proposed for beam based alignment was < 0.2 microns. Strength hysteresis was negligible. Thermal expansion of quadrupole and measurement parts caused a repeatable and easily compensated change in the vertical magnetic centerline. Calibration procedures as well as centerline measurements made over a wider tuning range of 100% to 20% in strength useful for a wide range of applications will be described. The impact of eddy currents in the steel poles on the magnetic field during strength adjustments will be reported. |
||
RPPP003 | Proposal of the Next Incarnation of Accelerator Test Facility at KEK for the International Linear Collider | 874 |
|
||
The realization of the International Linear Collider (ILC) will require the ability to create and reliably maintain nanometer size beams. The ATF damping ring is the unique facility where ILC emittancies are possible. In this paper we present and evaluate the proposal to create a final focus facility at the ATF which, using compact final focus optics and an ILC-like bunch train, would be capable of achieving 35nm beam size. Such a facility would enable the development of beam diagnostics and tuning methods, as well as the training of young accelerator physicists. |