Paper |
Title |
Page |
MPPH012 |
Design and Experience with the WS/HS Assembly Movement Using LabVIEW VIs, National Instrument Motion Controllers, and Compumotor Electronic Drive Units and Motors |
794 |
|
- D. Barr, L.A. Day, J.D. Gilpatrick, M.E. Gruchalla, D. Martinez, J.F. O'Hara, R.B. Shurter, M. Stettler, R. Valdiviez (LANL)
|
|
TOAA011 |
Measurements of Halo Generation for a Proton Beam in a FODO Channel |
170 |
|
- P.L. Colestock, C.K. Allen, K.C.D. Chan, R.W. Garnett, J.D. Gilpatrick, W.P. Lysenko, J.D. Schneider, R.L. Sheffield, H.V. Smith, T.P. Wangler (LANL) , M.E. Schulze (General Atomics) , K.R. Crandall (TechSource)
|
|
TPAH037 |
Analysis of Data from the LEDA Wire Scanner/Halo Scraper |
1306 |
|
- J.H. Kamperschroer (General Atomics) , J.F. O'Hara (Honeywell) , L.A. Day, J.D. Gilpatrick, D.M. Kerstiens (LANL)
|
|
TPAH040 |
Automated Control and Real-Time Data Processing of Wire Scanner/Halo Scraper Measurements |
1309 |
|
- L.A. Day, D. Barr, J.D. Gilpatrick, D.M. Kerstiens, M. Stettler (LANL) , J.H. Kamperschroer (General Atomics) , M.E. Gruchalla, J.F. O'Hara (Honeywell Corporation)
|
|
TPAH042 |
Experience with Photomultiplier Based Beam Loss Monitors (PMBLM) at the Low Energy Demonstration Accelerator (LEDA) |
1315 |
|
- W.C. Sellyey, J.D. Gilpatrick, P.S. Marroquin (LANL) , M.E. Gruchalla (Honeywell Corporation)
|
|
TPAH043 |
Bench Test of a Residual Gas Ionization Profile Monitor (RGIPM) |
1318 |
|
- W.C. Sellyey, J.D. Gilpatrick (LANL) , R. Senior (General Atomics)
|
|
TPAH045 |
The Final Mechanical Design, Fabrication, and Commissioning of a Wire Scanner and Scraper Assembly for Halo-Formation Measurements in a Proton Beam |
1324 |
|
- R. Valdiviez, D. Bruhn, J.D. Gilpatrick, H. Haagenstad, J.E. Ledford, F. Martinez, N. Patterson, A. Rendon, T. Wright (LANL) , D. Martinez (General Atomics) , J.F. O'Hara (Honeywell)
|
|
TPAH068 |
Upgrade to Initial BPM Electronics Module and Beamline Components for Calibration of the LEDA Beam Position Measurements |
1369 |
|
- D. Barr, J.D. Gilpatrick, R.B. Shurter (LANL)
|
|
TPAH071 |
Analog Front-End Electronics for Beam Position Measurement on the Beam Halo Measurement |
1378 |
|
- R.B. Shurter, T. Cote, J.D. Gilpatrick (LANL)
|
|
WPAH097 |
Experience with the Low Energy Demonstration Accelerator (LEDA) Halo Experiment Beam Instrumentation |
2311 |
|
- J.D. Gilpatrick, D. Barr, P.L. Colestock, L.A. Day, W.C. Sellyey, R.B. Shurter, M. Stettler, R. Valdiviez (LANL) , J.H. Kamperschroer, M.E. Schulze (General Atomics) , M.E. Gruchalla, J.F. O'Hara (Honeywell Corporation)
|
|
WPAH098 |
Beam Profile Wire-Scanner/Halo-Scraper Sensor Analog Interface Electronics |
2314 |
|
- M.E. Gruchalla, J.F. O'Hara (Honeywell FM&T/NM) , D. Martinez (General Atomics) , D. Barr, T. Cote, L.A. Day, J.D. Gilpatrick, M. Stettler (LANL)
|
|
ROAB004 |
Beam-Profile Instrumentation for Beam-Halo Measurement: Overall Description and Operation |
525 |
|
- J.D. Gilpatrick, D. Barr, L.A. Day, D.M. Kerstiens, M. Stettler, R. Valdiviez (LANL) , J.H. Kamperschroer (General Atomics) , M.E. Gruchalla, J.F. O'Hara (Honeywell Corporation)
|
|
RPAH032 |
Experimental Study of Proton-Beam Halo Induced by Beam Mismatch in LEDA |
2923 |
|
- T.P. Wangler, C.K. Allen, K.C.D. Chan, P.L. Colestock, R.W. Garnett, J.D. Gilpatrick, W.P. Lysenko, J. Qiang, J.D. Schneider, R.L. Sheffield, H.V. Smith (LANL) , M.E. Schulze (General Atomics) , K.R. Crandall (TechSource, Santa Fe, NM 87594-1057)
|
|
RPAH089 |
Characterizing Proton Beam of 6.7 MeV LEDA RFQ by Fitting Wire-Scanner Profiles to 3-D Nonlinear Simulations |
3051 |
|
- W.P. Lysenko, J.D. Gilpatrick, J. Qiang, L.J. Rybarcyk, R.D. Ryne, J.D. Schneider, H.V. Smith, L.M. Young (LANL) , M.E. Schulze (General Atomics)
|
|
ROPA011 |
Characterization of the Proton Beam from the 6.7 MeV LEDA RFQ |
591 |
|
- M.E. Schulze (General Atomics) , C.K. Allen, P.L. Colestock, J.D. Gilpatrick, W.P. Lysenko, L.J. Rybarcyk, J.D. Schneider, R.L. Shefffield, H.V. Smith, T.P. Wangler (LANL) , K.R. Crandall (TechSource)
|
|