| Paper | Title | Page |
|---|---|---|
| TUPMK002 | First Tests of the Apple II Undulator for the LOREA Insertion Device and Front End | 1488 |
|
||
| ALBA synchrotron is currently installing the new beamline LOREA (Low-Energy Ultra-High-Resolution Angular Photoemission for Complex Materials at ALBA). It operates in the range of 10 - 1500 eV with polarized light. To produce the light for the beamline, an Apple II undulator with a period of 125 mm has been chosen. It can operate as an undulator at low energies and as a wiggler at high energies, providing a wide energy range. The device was built by KYMA, delivered on February 2017 and installed in August 2017. We present the magnetic measurements made during SAT as well as the simulations of the influence of the ID in the electron beam dynamics and the first measurements with beam. On the other hand, the high demanding characteristics of the beamline lead to a device providing high power and wide beam in some working modes. This situation has been a challenge for the Front End (FE) thermal load. It has been built by the companies RMP and TVP, and the FE modules have been installed in the tunnel along autumn 2017. We present the Site Acceptance Tests results as well as the technical solutions adopted, especially in terms of mechanical design and used materials. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUPMK002 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| THPMF013 | The Stripline Kicker Prototype for the CLIC Damping Rings at ALBA: Installation, Commissioning and Beam Characterisation | 4062 |
|
||
|
The extraction system for the CLIC Damping Rings has very tight specifications. Therefore a full characterisation of the behaviour of the stripline kicker under conditions as close as possible to the expected working conditions will be very valuable. To that end the CLIC stripline has been installed in the ALBA Synchrotron Light Source and has been characterised with beam. Prior to its installation, the effect of the stripline kicker on the machine impedance has been assessed. The installation has required the design of an absorber to screen the stripline from synchrotron radiation and additional BPMs have been installed for a better kick angle determination. The commissioning of the stripline with beam has been performed following closely beam parameters, pressure and temperature. The studies with beam include the determination of the longitudinal and transverse impedance of the kicker*, the field homogeneity when excited with a dc field and the field ripple when pulsed. This contribution reports on the first experience with the stripline kicker for the CLIC DR in the ALBA storage ring and presents the results of the initial beam characterisation.
* M. Carla et al., "Beam based impedance measurements of the CLIC stripline at ALBA", Proc. of IPAC'2017. |
||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THPMF013 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |