Author: Hasegawa, K.
Paper Title Page
TUPAK009 Muon Profile Measurement After Acceleration With a Radio-Frequency Quadrupole Linac 977
 
  • M. Otani, Y. Fukao, K. Futatsukawa, N. Kawamura, T. Mibe, Y. Miyake, T. Yamazaki
    KEK, Ibaraki, Japan
  • S. Bae, H. Choi, S. Choi, B. Kim, H.S. Ko
    SNU, Seoul, Republic of Korea
  • K. Hasegawa, Y. Kondo, T. Morishita
    JAEA/J-PARC, Tokai-mura, Japan
  • T. Iijima, Y. Sue
    Nagoya University, Graduate School of Science, Chikusa-ku, Nagoya, Japan
  • H. Iinuma, Y. Nakazawa
    Ibaraki University, Ibaraki, Japan
  • K. Ishida
    RIKEN Nishina Center, Wako, Japan
  • R. Kitamura
    University of Tokyo, Tokyo, Japan
  • S. Li
    The University of Tokyo, Graduate School of Science, Tokyo, Japan
  • G.P. Razuvaev
    Budker INP & NSU, Novosibirsk, Russia
  • N. Saito
    J-PARC, KEK & JAEA, Ibaraki-ken, Japan
  • E. Won
    Korea University, Seoul, Republic of Korea
 
  Funding: This work is supported by JSPS KAKENHI Grant Numbers JP15H03666, JP16H03987, and JP16J07784.
The E34 experiment aims to measure muon anomalous magnetic moment with a precision of 0.1ppm. The experiment utilizes low emittance muon beam with a muon linac to sweep out beam related uncertainties, which limit the g-2 precision in past experiments. A beam matching with precise beam measurements is required to avoid substantial emittance growth and satisfy the experimental requirement on the beam emittance of around 1.5 pi mm mrad. We conduct profile measurement of muon after acceleration with a radio-frequency quadrupole (RFQ) on December 2017 following a first muon acceleration experiment on October. In the experiment of profile measurement, epi-thermal negative muonium ions are generated by injecting surface muons to a thin metal foil. The muonium ions are accelerated to 5 keV. by an electro-static lens and accelerated to 90 keV by the RFQ. Then the muonium ions are transported to a profile detector consisting of a micro-channel plate and a ccd camera via a quadrupole pair and a bending magnet. In this poster, the experimental result and comparison to the simulation are reported.
 
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUPAK009  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
TUPAL017 Performance and Status of the J-PARC Accelerators 1038
 
  • K. Hasegawa, N. Hayashi, M. Kinsho, H. Oguri, K. Yamamoto, Y. Yamazaki
    JAEA/J-PARC, Tokai-Mura, Naka-Gun, Ibaraki-Ken, Japan
  • T. Koseki, F. Naito, M. Yoshii
    KEK, Tokai, Ibaraki, Japan
  • N. Yamamoto
    J-PARC, KEK & JAEA, Ibaraki-ken, Japan
 
  The J-PARC is a high intensity proton facility and the accelerator consists of a 400 MeV linac, a 3 GeV Rapid Cycling Synchrotron (RCS) and a 30 GeV Main Ring Synchrotron (MR). Regarding 3 GeV beam from the RCS, we delivered it at 150 kW to the materials and life science experimental facility (MLF), for the neutron and muon users. The beam powers for the neutrino experiment at 30 GeV was 420 kW in May 2016, but increased to 470 kW in February 2017 thanks to the change and optimization of operation parameters. For the hadron experimental facility which uses a slow beam extraction mode at 30 GeV, we delivered beam at a power of 37 kW, after the recovery from a trouble at an electro static septum. We have experienced many failures and troubles to impede full potential and high availability. In this report, operational performance and status of the J-PARC accelerators are presented.  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUPAL017  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
TUPAL076 Result of the First Muon Acceleration with Radio Frequency Quadrupole 1190
 
  • R. Kitamura
    University of Tokyo, Tokyo, Japan
  • S. Bae, B. Kim
    SNU, Seoul, Republic of Korea
  • Y. Fukao, K. Futatsukawa, N. Kawamura, T. Mibe, Y. Miyake, M. Otani, T. Yamazaki
    KEK, Ibaraki, Japan
  • K. Hasegawa, Y. Kondo, T. Morishita
    JAEA/J-PARC, Tokai-mura, Japan
  • H. Iinuma, Y. Nakazawa
    Ibaraki University, Ibaraki, Japan
  • G.P. Razuvaev
    Budker INP & NSU, Novosibirsk, Russia
  • N. Saito
    J-PARC, KEK & JAEA, Ibaraki-ken, Japan
  • Y. Sue
    Nagoya University, Graduate School of Science, Chikusa-ku, Nagoya, Japan
 
  Funding: This work is supported by JSPS KAKENHI Grant Numbers JP15H03666, JP16H03987, and JP16J07784.
J-PARC E34 experiment aims to measure the muon g-2/EDM precisely with novel techniques including the muon linear accelerator. Slow muon source by the metal foil method in order to cool the muon beam has been developed for the muon acceleration test with RF accelerator, because the muon beam derived from the proton driver was the tertiary beam and has a large emittance. The first verification test of the muon acceleration with RFQ was carried out at the muon test beam line of J-PARC MLF in October 2017. The incident surface muons were decelerated by the thin metal foil target and produced the negative muonium ions (Mu-), which is the bound stat of a positive muon and two electrons. After Mu- were extracted by a electrostatic accelerator as the injector of the RFQ, they were accelerated with RFQ to 88.6 keV. The accelerated Mu- were identified by the momentum selection with the bending magnet after the RFQ, and the measurement of the Time-Of-Flight. Accelerated Mu- were easily distinguished from penetrated positive muons by the difference of the polarity. The latest analysis result of the world's first muon acceleration with RFQ will be reported in this paper.
 
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUPAL076  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
FRXGBF1 Re-Acceleration of Ultra Cold Muon in J-PARC Muon Facility 5041
 
  • Y. Kondo, K. Hasegawa, T. Morishita
    JAEA/J-PARC, Tokai-mura, Japan
  • S. Bae, H. Choi, S. Choi, B. Kim, H.S. Ko
    SNU, Seoul, Republic of Korea
  • Y. Fukao, K. Futatsukawa, N. Kawamura, T. Mibe, Y. Miyake, M. Otani, K. Shimomura, T. Yamazaki, M. Yoshida
    KEK, Ibaraki, Japan
  • N. Hayashizaki
    RLNR, Tokyo, Japan
  • T. Iijima, Y. Sue
    Nagoya University, Graduate School of Science, Chikusa-ku, Nagoya, Japan
  • H. Iinuma, Y. Nakazawa
    Ibaraki University, Ibaraki, Japan
  • K. Ishida
    RIKEN Nishina Center, Wako, Japan
  • Y. Iwashita
    Kyoto ICR, Uji, Kyoto, Japan
  • Y. Iwata
    NIRS, Chiba-shi, Japan
  • R. Kitamura
    University of Tokyo, Tokyo, Japan
  • S. Li
    The University of Tokyo, Graduate School of Science, Tokyo, Japan
  • G.P. Razuvaev
    Budker INP & NSU, Novosibirsk, Russia
  • N. Saito
    J-PARC, KEK & JAEA, Ibaraki-ken, Japan
 
  Funding: This work is supported by JSPS KAKENHI Grant Numbers JP15H03666, JP16H03987, and JP16J07784.
J-PARC is developing the reacceleration system of the ultra slow (30 meV) muon (USM) obtained by two-photon laser resonant ionization of muonium atoms. The muon beam thus obtained has low emittance, meeting the requirement for the g-2/EDM experiment. J-PARC E34 experiment aims to measure the muon anomalous magnetic moment (g-2) with a precision of 0.1 ppm and search for EDM with a sensitivity to 10-21 e cm. The USM's are accelerated to 212 MeV by using a muon dedicated linac to be a ultra cold muon beam. The muon LINAC consists of an RFQ, a inter-digital H-mode DTL, disk and washer coupled cell structures, and disk loaded structures. The ultra-cold muons will have an extremely small transverse momentum spread of 0.1% with a normalized transverse emittance of around 1.5 pi mm-mrad. Proof of the slow muon acceleration scheme is an essential step to realize the world first muon linac. In October 2017, we have succeeded to accelerate slow negative muoniums generated using a simpler muonium source to 89 keV. In this talk, present design of the muon linac and the result of the world first muon acceleration experiment are reported.
 
slides icon Slides FRXGBF1 [8.373 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-FRXGBF1  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)