Paper | Title | Page |
---|---|---|
WEPAL062 | Bunch Length Measurements with a Streak Camera in Low Alpha Lattice Operation at the TPS | 2316 |
|
||
We developed and tested lattice with lower momentum compaction factor (low alpha) in TPS (Taiwan Photon Source) recently. Operating low alpha lattice can provide picosecond bunch length for time-resolved research and coherent IR/THz synchrotron light. The bunch length around 2.5 picosecond rms was measured by a streak camera* in low alpha mode while operating in the routine users mode** it was around 10 picosecond. This paper presents the related processes and measurements.
* L.Y. Liao et al., "Preliminary beam test of synchrotron radiation monitoring system at Taiwan Photon Source", IPAC'15. ** C.C. Kuo et al., "Commissioning of Taiwan Photon Source", IPAC'15. |
||
DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-WEPAL062 | |
Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
THPAK053 | Side Effects of Local Bump in TPS Storage Ring | 3340 |
|
||
The Taiwan Photon Source (TPS) is a low-emittance 3-GeV light source at National Synchrotron Radiation Research Center. Five in-vacuum undulator beamlines were delivered to users on Sep. 22, 2016. Another 2 EPU beamlines will be open to user in near future. In the beginning, the local bump was used to do ID spectrum optimization since 2016. After this procedure, the ID spectrum are consistent between theoretical simulation and measurement. Recently, we found the local bump will cause tune shift and orbit distortion. In this paper, we will present the effect of local bump in TPS. | ||
DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THPAK053 | |
Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
THPAK055 | Suppression of Transverse Beam Instabilities by Stripline Kickers at TPS | 3346 |
|
||
Collective beam instabilities could limit the accelerator performance if proper countermeasures are not in place. Active beam feedback systems are commonly used to suppress beam instabilities. The resistive wall impedance including phase-II insertion devices at TPS are calculated with analytical formulas. The growth rate of transverse coupled bunch instabilities due to wall impedance is estimated by theory. The RF properties of existing stripline kickers in TPS are analyzed with a 3-D electromagnetic simulation code GdfidL. Based on the above analysis, the requirements for a beam feedback system are calculated and the results are reported. | ||
DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THPAK055 | |
Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
THPAL059 | TEMPERATURE ISSUES OF THE TPS BPMS | 3781 |
|
||
Since the TPS is capable to operate at higher currents, long-term 400mA conditioning runs were conducted. Current-dependent temperature data of BPMs were collected and analysed for both, aluminium and stainless steel BPM chambers. To better understand beam coupling effects in different types of TPS BPMs, electromagnetic and thermal simulation models were established. In this paper, we discuss associated results of such studies. | ||
DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THPAL059 | |
Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |