IPAC2018 - List of Authors (Calvey, J.R.)

Paper	Title	Page
WEPAF006	Fast Photodetector Bunch Duration Monitor for the Advanced Photon Source Particle Accumulator Ring	1819
	J.C. Dooling, J.R. Calvey, K.C. Harkay, B.X. Yang, C. Yao ANL, Argonne, Illinois, USA
	Funding: Work supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357. A fast photodetector is used to monitor the bunch duration in the Advanced Photon Source (APS) Particle Accumulator Ring (PAR). The Bunch Duration Monitor (BDM) diagnostic provides an accurate measure of the PAR bunch length. PAR BDM data show good agreement with streak camera measurements. The BDM is based on the metal-semiconductor-metal (MSM) photodetector Hamamatsu G4176-03 MSM with specified rise and fall times of 30 ps. The BDM has sufficient frequency response to resolve the PAR bunch near extraction where, under low-charge conditions, minimum rms pulse durations of 200-300 ps are observed. Beam from the PAR is injected into the Booster; for efficient capture, injected rms bunch duration from the PAR must be less than 600 ps. The MSM detector exhibits a ringing response to fast input signals. To overcome this, the BDM output is de-convolved with the impulse response function of the detector-amplifier circuit. Turn-by-turn bunch duration data is presented versus charge and time in the PAR cycle. Charge calibration is used to determine fit parameters for bunch duration measurements in peak-detection mode. Observations relevant to APS Upgrade high-charge studies are presented.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-WEPAF006
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

THXGBD1	The Upgrade of the Advanced Photon Source	2872
	M. Borland, M. Abliz, N.D. Arnold, T.G. Berenc, J.M. Byrd, J.R. Calvey, J.A. Carter, J. Carwardine, H. Cease, Z.A. Conway, G. Decker, J.C. Dooling, L. Emery, J.D. Fuerst, K.C. Harkay, A.K. Jain, M.S. Jaski, P.S. Kallakuri, M.P. Kelly, S.H. Kim, R.M. Lill, R.R. Lindberg, J. Liu, Z. Liu, J. Nudell, C.A. Preissner, V. Sajaev, N. Sereno, X. Sun, Y.P. Sun, S. Veseli, J. Wang, U. Wienands, A. Xiao, C. Yao ANL, Argonne, Illinois, USA A. Blednykh BNL, Upton, Long Island, New York, USA
	After decades of successful operation as a 7-GeV synchrotron radiation source, the Advanced Photon Source is pursing a major upgrade that involves replacement of the storage ring with an ultra-low emittance multi-bend achromat design. Using a seven-bend hybrid multi-bend achromat with reverse bending magnets gives a natural emittance of 42 pm operated at 6 GeV. The x-ray brightness is predicted to increase by more than two orders of magnitude. Challenges are many, but appear manageable based on thorough simulation and in light of the experience gained from world-wide operation of 3^\text{rd}-generation light sources. The upgraded ring will operate in swap-out mode, which has allowed pushing the performance beyond the limits imposed by conventional operation.
	Slides THXGBD1 [14.684 MB]
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THXGBD1
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Fast Photodetector Bunch Duration Monitor for the Advanced Photon Source Particle Accumulator Ring

1819

J.C. Dooling, J.R. Calvey, K.C. Harkay, B.X. Yang, C. Yao
ANL, Argonne, Illinois, USA

Funding: Work supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357.
A fast photodetector is used to monitor the bunch duration in the Advanced Photon Source (APS) Particle Accumulator Ring (PAR). The Bunch Duration Monitor (BDM) diagnostic provides an accurate measure of the PAR bunch length. PAR BDM data show good agreement with streak camera measurements. The BDM is based on the metal-semiconductor-metal (MSM) photodetector Hamamatsu G4176-03 MSM with specified rise and fall times of 30 ps. The BDM has sufficient frequency response to resolve the PAR bunch near extraction where, under low-charge conditions, minimum rms pulse durations of 200-300 ps are observed. Beam from the PAR is injected into the Booster; for efficient capture, injected rms bunch duration from the PAR must be less than 600 ps. The MSM detector exhibits a ringing response to fast input signals. To overcome this, the BDM output is de-convolved with the impulse response function of the detector-amplifier circuit. Turn-by-turn bunch duration data is presented versus charge and time in the PAR cycle. Charge calibration is used to determine fit parameters for bunch duration measurements in peak-detection mode. Observations relevant to APS Upgrade high-charge studies are presented.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-WEPAF006

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

THXGBD1

The Upgrade of the Advanced Photon Source

2872

M. Borland, M. Abliz, N.D. Arnold, T.G. Berenc, J.M. Byrd, J.R. Calvey, J.A. Carter, J. Carwardine, H. Cease, Z.A. Conway, G. Decker, J.C. Dooling, L. Emery, J.D. Fuerst, K.C. Harkay, A.K. Jain, M.S. Jaski, P.S. Kallakuri, M.P. Kelly, S.H. Kim, R.M. Lill, R.R. Lindberg, J. Liu, Z. Liu, J. Nudell, C.A. Preissner, V. Sajaev, N. Sereno, X. Sun, Y.P. Sun, S. Veseli, J. Wang, U. Wienands, A. Xiao, C. Yao
ANL, Argonne, Illinois, USA
A. Blednykh
BNL, Upton, Long Island, New York, USA

After decades of successful operation as a 7-GeV synchrotron radiation source, the Advanced Photon Source is pursing a major upgrade that involves replacement of the storage ring with an ultra-low emittance multi-bend achromat design. Using a seven-bend hybrid multi-bend achromat with reverse bending magnets gives a natural emittance of 42 pm operated at 6 GeV. The x-ray brightness is predicted to increase by more than two orders of magnitude. Challenges are many, but appear manageable based on thorough simulation and in light of the experience gained from world-wide operation of 3^\text{rd}-generation light sources. The upgraded ring will operate in swap-out mode, which has allowed pushing the performance beyond the limits imposed by conventional operation.

Slides THXGBD1 [14.684 MB]

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-THXGBD1

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)