RISE, Tokyo, Japan
BNL, Upton, Long Island, New York, USA
High intensity, high charge state, various ion species and small emittance heavy ion beam is required for particle physics, medical uses, inertial fusion, and a simulator of space radiation. Direct Plasma Injection Scheme (DPIS), the way to make laser abrasion plasma developed in the past several years, is used for Heavy Ion beam Accerelation. High density plasma with an initial drift velocity will fly to the entrance of the Radio Frequency Quadropole (RFQ) LINAC; ions will be separated from plasma via high voltage and injected it to RFQ LINAC directly. After RFQ LINAC, ions accepted to the RF buckets are accelerated to a current of over 10mA. Until now, we tried a carbon target using the partial modulation rod of the RFQ LINAC, and succeeded in accelerating carbon4+, carbon5+, and carbon6+ non-bunched beam.* In this instance, we succeeded in commissioning of new full modulation RFQ rod designed for the charge mass ratio(q/A) 1/6. We tested the acceleration of carbon4+, and it could be catched by the RF bucket and accelerated. After this, we'll try accelerating carbon2+ (q/A=1/6) for demonstrating the feasibility of the Ag15+ ion accelerating.
* T. Kanesue, M. Okamura, K. Kondo, J. Tamura, H. Kashiwagi, Z. Zhang, Drift distance survey in direct plasma injection scheme for high current beam production, Rev Sci Instrum. 2010 Feb;81(2):02B723
BNL, Upton, Long Island, New York, USA
In polarized proton operation, the RHIC performance is limited by the head-on beam-beam effect. To overcome these limitations two electron lenses are under construction. We give an overview of the progress over the last year. Guns, collectors and the warm electron beam transport solenoids with their associated power supplies have been constructed. The superconducting solenoids that guide the electron beam during the interaction with the proton beam are near completion. A test stand has been set up to verify the performance of gun, collector and some of the instrumentation. The RHIC infrastructure is being prepared for installation, and simulations continue to optimize the performance.
BNL, Upton, Long Island, New York, USA
To compensate for the beam-beam effects from the proton-proton interactions at IP6 and IP8 in the Relativistic Heavy Ion Collider (RHIC), we are fabricating two electron lenses that we plan to install at RHIC IR10. Before installing the e-lenses, we are setting-up the e-lens test bench to test the electron gun, collector, GS1 coil, modulator, partial control system, some instrumentation, and the application software. Some e-lens power supplies, the electronics for current measurement will also be qualified on test bench. The test bench also was designed for measuring the properties of the cathode and the profile of the beam. In this paper, we introduce the layout and elements of the e-lens test bench; and we discuss its present status towards the end of this paper.
BNL, Upton, Long Island, New York, USA
Time Corporation, Hiroshima, Japan
Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy.
BNL, Upton, Long Island, New York, USA
We are designing two electron lenses that will be installed at RHIC IR10 to compensate for the head-on beam-beam effect. To clear accumulated scattered electrons from 100 GeV proton-electron head-on collisions in the e-lens, a clearing split electrode may be constructed. The feasibility of this proposed electrode was demonstrated via the CST Particle Studio and Opera program simulations. By splitting one of the drift tubes in the e-lens and applying ~ 380 V across the two parts, the scattered electrons can be cleared out within several hundred micro-seconds. At the same time we can restrict the unwanted shift of the primary electron-beam that already passed the 2-m interaction region in e-lens, to less than 15um.